Abstract:Silicon nanopore arrays (SiNPs) were prepared by a two-step inductively coupled plasma (ICP) etching process using a self-assembled anodic aluminum oxide film mask. The influence of etching parameters (first-step etching time, Cl-2 proportion in the etching gas, etching pressure, ICP power, and radio frequency (RF) power) on the morphology of the SiNPs were systematically investigated. The results revealed that the first step of ICP etching can effectively remove the barrier layer of the mask. Higher Cl-2 proportion and lower etching pressure increase the chemical corrosion and physical bombardment of ICP etching, respectively, which may damage the porous morphology. ICP power affects both chemical reaction etching and physical bombardment, but the RF power mainly affects physical etching. The etching rate is positively correlated with Cl-2 proportion and RF power, and negatively correlated with etching pressure. The optimized first-step etching time, Cl-2/Ar ratio, etching pressure, ICP power and RF power for high-quality SiNPs are approximately 10 s, 60%, 7 mTorr, 900 W and 100 W, respectively. Precise control of the pore size and depth of the SiNPs can be achieved using this controllable growth process. These results demonstrate a simple and controllable way to achieve good quality SiNPs with desired sizes.

Shape Formation Analysis of Silicon Nanopore Fabricated by Anisotropic Wet Etching Method

Massive Fabrication of Silicon Nanopore Arrays with Tunable Shapes

Fabrication of Silicon Nanopores with Tunable Shapes and Sizes

Fabrication of nanopores and nanoslits with feature sizes down to 5 nm by wet etching method

Fabrication of Silicon Nanopore Arrays with Three-Step Wet Etching

Fabrication of Silicon Nanopore Arrays Using A Combination of Dry and Wet Etching

Fabrication Of Inverted-Pyramid Silicon Nanopore Arrays With Three-Step Wet Etching

Fabrication of Nanopore and Nanopore Arrays in Si Substrate by Wet Etching Method at Wafer Scale

A Two-Step Etching Method to Fabricate Nanopores in Silicon

Controllable Fabrication of Silicon Nanopore Arrays by Two-Step Inductively Coupled Plasma Etching Using Self-Assembled Anodic Aluminum Oxide Mask

High Aspect Ratio Etching of Nanopores in PECVD SiC Through AAO Mask

Method for Fabricating Micro/Nanostructures Via Scanning Probe Microscope and Anisotropic Wet Etching

Fabrication of Polygonal Nanoholes by Localized Mask-Free Wet Anisotropic Etching

Achieving a sub-10 nm nanopore array in silicon by metal-assisted chemical etching and machine learning

The Formation of Self-Sharpening Nano-Silicon-Tips by Single Step Etching

Fabrication of silicon-based multilevel nanostructures via scanning probe oxidation and anisotropic wet etching

Morphological and crystallographic evolution of patterned silicon substrate etched in TMAH solutions

Electrochemically Etched Pore Array in Silicon with Large Spacing and High-Aspect-ratio

Wafer-Scale Fabrication of V-Shaped Silicon Nano-Slit Arrays

Controllable Fabrication of Pyramidal Silicon Nanopore Arrays and Nanoslits for Nanostencil Lithography

Local Formation of Macroporous Silicon Through a Mask