Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Failure Analysis of a PLL ESD Structure Design Defect

Transient Electrothermal Analysis of Multilevel Interconnects in the Presence of ESD Pulses Using the Nonlinear Time-Domain Finite-Element Method

Implementation Of Temperature Dependent Contact Resistance Model For The Analysis Of Deep Submicron Devices Under Esd

Electro-Thermo-Mechanical Investigation On Multi-Level Interconnects In The Presence Of An Esd Pulse

A Cross-Layer Framework for Early-Stage Full Chip Oxide Breakdown Reliability Analysis

On the ESD Protection and Non-Fatal ESD Strike on Nano CMOS Devices

Comparative Study of Reliability Degradation Behaviors of LDMOS and LDMOS-SCR ESD Protection Devices

FOD Based ESD Protection Devices in Deep Sub-micron Technology

Investigation of Problems in JEDEC HBM ESD Test Standard

Evaluation of RF electrostatic discharge (ESD) protection in 0.18-μm CMOS technology

A Systematic Study of ESD Protection Co-Design with High-Speed and High-Frequency ICs in 28 Nm CMOS.

Effects of Non-Fatal Electrostatic Discharge on the Threshold Voltage Degradation in Nano CMOS Devices

System Efficient ESD Design of IO ESD Protection

Failure analysis of ESD damage on interconnects in LCD GOA

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

A Case Study of Problems in JEDEC HBM ESD Test Standard

An Analysis Method of System-Level ESD Model with a TLP Stress Input

Challenges: ESD Protection for Heterogeneously Integrated SoICs in Advanced Packaging

On-chip ESD Protection Design for Integrated Circuits: an Overview for IC Designers

On-Chip ESD Protection Design for Ics

Failure Analysis on Diode-triggered Silicon-Controlled Rectifiers by Using Nondestructive X-ray Microscopy