Abstract:In this paper, we propose a simulation-based novel Split-Gate Trench MOSFET structure with an optimized fabrication process to enhance power efficiency, switching speed, and thermal stability for high-performance semiconductor applications. Integrating high-k pillars with superjunction structures beneath the split gate enhancing breakdown performance by reducing critical field intensity by up to 35%, the device achieves a 15% improvement in Figures of Merit (FOMs) for BV2/Ron,sp. Dynamic testing reveals approximately a 25% reduction in both input and output capacitance, as well as gate-to-drain charge (QGD). This reduction, coupled with an approximately 40% improvement in Baliga's High-Frequency Figure of Merit (BHFFOM) and over 20% increase in the New High-Frequency Figure of Merit (NHFFOM), underscores the design's suitability for high-speed, high-efficiency power electronics. Simulations examining the effects of high-k pillar depth indicate that an optimal depth of 3.5 um achieves a balanced performance between BV and Ron,sp. The influence of high-k materials on BT-Hk-SJ MOSFET performance was investigated by comparing hafnium dioxide (HfO2), nitride, and oxynitride. Among these, HfO2 demonstrated optimal performance across static, dynamic, and diode characteristics due to its high dielectric constant, while material choice had minimal impact, with variations kept within 5%.

Influence of the Filling Holes on the High Temperature Characteristics of Deep Trench Superjunction MOSFET

Research on Integrated Trench Etching for Trench-Type Power MOSFET

Failure Analysis and Improvement of Superjunction MOSFET under UIS Stress Condition

Fabrication and Optimization of a High Speed Deep-Trench Super-Junction MOSFET with Improved EMI Performance

Dv/dt Induced Failure and Improvement of Power Superjunction MOSFET

Experimental and Theoretical Study on Failure Mechanism of Superjunction MOSFET under H3TRB Testing

A Higher Breakdown Voltage and Lower Specific on Resistance Superjunction MOSFET with Non-normal Breakdown Voltage Distribution

Influence of JFET Width on Short-Circuit Robustness of 1200 V SiC Power MOSFETs

Design and Process Analysis of a Split-Gate Trench Power MOSFET with Bottom-Trench Hk-Pillar Superjunction for Enhanced Performance

Deep Insight of Self-Heating Effect Induced Hot Carrier Reliability Improvement in LDMOS Devices

Above 700 V Superjunction Mosfets Fabricated by Deep Trench Etching and Epitaxial Growth

A New Solution for Superjunction Lateral Double Diffused MOSFET by Using Deep Drain Diffusion and Field Plates

Analysis of SEB and SEGR in Super-Junction MOSFETs

A High Breakdown Voltage Superjunction MOSFET by Utilizing Double Trench Filling Epitaxy Growth

Fabrication and Optimization of a High-Reliability 700 V Super-Junction MOSFET with Segmented P-Buried RESURF Termination

High Temperature Characterization Of 4h-Sic Normally-On Vertical Jfets With Buried Gate And Buried Field Rings

Trench angle: a key design factor for a deep trench superjunction MOSFET

Impact Analysis of Off-State Avalanche-Breakdown Stress on 650 V-Class Superjunction MOSFET

A Novel Deep-Trench Super-Junction SiC MOSFET with Improved Specific On-Resistance

Interconnection Reliability on FinFET Devices

Deep oxide trench termination structure for super-junction MOSFET