Abstract:Abstract Mullite porous ceramics with high porosity and good mechanical properties were prepared by foaming method combined with gel casting process using kaolin and alumina as main raw materials and sodium polyoxyethylene ether sulfate as foaming agent. The effects of sintering process and magnesium oxide content on the microstructure and properties of mullite porous ceramics were investigated. The studies show that: With the addition of magnesium oxide, the amount of mullite produced and the compactness of the sample will increase. At this time, the microscopic morphology of mullite is needle-like and prismatic, and the mechanical properties are better. and the pore size distribution gradually tends to be between 0.1-0.2mm and 0.2-0.3mm. The addition of magnesium oxide, The amount of mullite phase increased, the densification degree of the sample increased, and the acicular and prismatic mullite phases with good mechanical properties were mainly formed, and the porosity of mullite porous ceramics decreased and the compressive strength increased. The pore size distribution gradually tends to be between 0.1-0.2mm and 0.2-0.3mm. As the sintering temperature increases, the porosity of mullite porous ceramics decreases and the compressive strength increases. With the extension of the holding time, the amount of mullite phase generated increases, the porosity remains basically unchanged, and the compressive strength increases.

Effect of Magnesium Oxide on Preparation of Mullite Fibers Via Sol-Gel Method

Study on Preparation of MgO Crystal Whisker from Magnesite

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Preparation of Mullite Fibers by Sol-Gel Process and Study of Their Morphology

Fabrication of Homogeneous Mullite-Based Fiber Porous Ceramics with High Strength and Porosity

Mullite Fibers Prepared by Sol-Gel Method Using Aluminum Chloride Aluminum Isopropoxide and Tetraethylorthosilicate

Fabrication of Y2O3-doped MgO Refractory Raw Materials Based on Magnesium Hydroxide from Salt-Lake Brine

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

Mullite Fiber Prepared by Sol-Gel Method Using Low-Molecular-Weight Acids as Modifying Agents

Effect Of Sintering Process On Micro-structure And Properties Of Mullite Porous Ceramics Containing magnesium oxide

Mullite Fibers Prepared from an Inorganic Sol–gel Precursor

Synthesis and Characterization of Rich Silica Mullite Fibers by Sol–Gel Method Using Aluminum Lactate and Silica Sol

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Influence of MgO on Properties and Microstructure of Mullite Ceramics Synthesized from Coal Fly Ash

Mullite Fibres Preparation by Aqueous Sol–gel Process and Activation Energy of Mullitization

Preparation and Mullitization Kinetics of Mullite Fibres via Sol-Gel Process

Preparation of Mullite Fibres by Sol–gel Processes Using Aluminium Carboxylates and Tetraethylorthosilicate

Preparation of Nanocrystalline Mullite Contained Microspheres by Sol-gel Process in Oil-in-Water Emulsion

The effects of solvent and microwave on the preparation of Magnesium Oxide Precursor: The effects of solvent and microwave on the preparation of Magnesium Oxide Precursor

Effect of Al2O3 + 4sio2 Additives on Sintering Behavior and Thermal Shock Resistance of MgO-Based Ceramics

Sintering and Characterization of Flyash-Based Mullite with MgO Addition