Abstract:The preparation of precursor sol is the first and crucial step in fabricating oxide fibers by the sol–gel method. In this study, different aluminum-silica sols were prepared by adjusting the alumina and silica source mixing procedure using aluminum carboxylate sol and tetraethoxysilane (TEOS) as the aluminum source and silicon source, respectively. Continuous alumina-mullite precursor fibers were obtained by dry spinning and the effects of alumina and silica source mixing procedure on the phase transition and microstructure evolution of alumina-mullite composite fibers were investigated. The results showed that the mullite formation temperature in the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was about 1300 °C, while it was 800 °C in the fibers obtained by mixing aluminum carboxylate sol and TEOS. In addition, the grain size of the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was significantly smaller than that obtained by mixing aluminum carboxylate sol and TEOS. The mechanism of this difference was that the aluminum-silica sol obtained by adding TEOS during the preparation of aluminum carboxylate sol was a diphasic sol, while the aluminum-silica sol obtained by adding TEOS in the prepared aluminum carboxylate sol was a monophasic sol.Graphical Abstract

Mullite Fibers Prepared by Sol-Gel Method Using Aluminum Chloride Aluminum Isopropoxide and Tetraethylorthosilicate

Preparation of Mullite Fibers by Sol-Gel Process and Study of Their Morphology

Mullite Fibers Prepared from an Inorganic Sol–gel Precursor

Preparation of Mullite Fibres by Sol–gel Processes Using Aluminium Carboxylates and Tetraethylorthosilicate

Fabrication of Homogeneous Mullite-Based Fiber Porous Ceramics with High Strength and Porosity

Mullite Fibres Preparation by Aqueous Sol–gel Process and Activation Energy of Mullitization

Synthesis and Characterization of Rich Silica Mullite Fibers by Sol–Gel Method Using Aluminum Lactate and Silica Sol

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Mullite Fiber Prepared by Sol-Gel Method Using Low-Molecular-Weight Acids as Modifying Agents

Preparation and Mullitization Kinetics of Mullite Fibres via Sol-Gel Process

Effect of Magnesium Oxide on Preparation of Mullite Fibers Via Sol-Gel Method

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

Mullite Fibres Prepared by Sol–gel Method Using Polyvinyl Butyral

A morphological study of mullite long fiber prepared using polyvinyl butyral as spinning aids

The characteristics of spinnable mullite sol prepared by sol-gel method

Preparation of Mullite Monoliths with Well-Defined Macropores and Mesostructured Skeletons Via the Sol–gel Process Accompanied by Phase Separation

Synthesis of Mullite Fibers Using Electrospun Fiber Template

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Activation Energy for Mullitization of Gel Fibres Obtained from Aluminum Isopropoxide

Molten Salt Synthesis of Mullite Whiskers from Silicon Carbide Precursor

Preparation of Nanocrystalline Mullite Contained Microspheres by Sol-gel Process in Oil-in-Water Emulsion