Abstract:Mordenite composite membranes were prepared by means of coating a porous α-alumina support with nanosized mordenite seeds followed by hydrothermal crystallization. A systematic investigation was performed on the influence of several factors such as ageing of the reaction mixture, alkalinity, salt addition and temperature on the formation of a mordenite membrane on the seeded support. The ageing of the reaction mixture reduces the growth rate of mordenite crystal along a-axis and b-axis but hardly influences the growth rate along c-axis. As a result, the boundaries between the surface crystals become a little larger with prolonging the period of ageing time. The growth rate of the mordenite crystal along individual axes increases first and then decreases with increasing concentration of sodium hydroxide. A higher alkalinity is unfavorable for the formation of a continuous mordenite membrane. The addition of salt in the reaction mixture has different effect on the growth rate of the mordenite crystal along each axis. With increasing the amount of salt, there was hardly influence on the growth rate along c-axis, whereas an obvious decline was observed in the growth rate along either a-axis or b-axis, which enlarges the boundaries between the surface crystals. The growth rate of the mordenite crystal increases more along c-axis than that along a-axis or b-axis with increasing temperature for hydrothermal crystallization. The use of a temperature as high as 473 K produces a membrane composed of bar-like crystals with larger boundaries.

Preparation of Nanocrystalline Mullite Contained Microspheres by Sol-gel Process in Oil-in-Water Emulsion

Preparation of Mullite Monoliths with Well-Defined Macropores and Mesostructured Skeletons Via the Sol–gel Process Accompanied by Phase Separation

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Preparation of Mordenite Composite Membranes with Seeding

Preparation of Al2O3 Porous Microspheres via an Emulsion Method Combined with a Sol-gel Method

Preparation of Mullite Fibers by Sol-Gel Process and Study of Their Morphology

Preparation and Crystallization of Si-Al Gel

Preparation of porous alumina microspheres via an oil-in-water emulsion method accompanied by a sol–gel process

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Synthesis and Controlled Growth of Mullite Submicron Powders

Preparation and Characterization of Mullite Whiskers from Different Silica Sources via Molten Salt Reaction

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

The Formation of Alumina Ceramic Microspheres by Internal Gelation Process

Preparation of Dense Mullite Ceramics through Gelcasting of Alumina Slurry Dispersed in Silica Sol

Preparation of silica microspheres by hydrolysis of silicon tetrachloride in microemulsion

Preparation of spherical α‐Al 2 O 3 nanoparticles by microwave hydrothermal synthesis and addition of nano‐Al seeds

Preparation of Homogeneous Super-Circular Alumina Microspheres in Microchannels by Controlling Extraction and Motion Processes

PREPARATION AND CHARACTERIZATION OF ALUMINA NANOCRYSTALLINE POWDER BY COMPLEXING SOL-GEL METHOD

Preparation of mullite ceramics with equiaxial grains from powders synthesized by the sol-gel method

Ultrasonic Synthesis of Silica−Alumina Nanomaterials with Controlled Mesopore Distribution Without Using Surfactants

Submicron Mullite Hollow Spheres Synthesized Via UV Polymerization of Pickering Emulsions