Abstract:This paper deals with a systematic investigation on the synthesis of aluminium oxide starting from mono hydroxy aluminium oxide (boehmite, (AlOOH)) which in turn is synthesized from aluminium nitrate. Boehmite on heating forms γ, transitional alumina and α-alumina phases in the temperature range 400–600, 800–1050 and 1050–1100°C respectively. Calculation from XRD, using Scherer equation shows that γ-alumina has crystallite size in the range 5–10 nm, while δ and θ-alumina are in the range 10–20 nm and α-alumina is about ∼33 nm. The textural features of aqueous sol-gel boehmite samples calcined at various temperatures were analyzed by specific surface area measurements and adsorption isotherm features. Maximum specific surface area of 266 m2/g is observed for the precursor calcined at 400°C and a minimum of 5 m2/g at 1100°C. Total pore volume is maximum for the precursor calcined at 600°C (0.2653 cm3/g). Average pore size ranges from ∼3 nm (400°C) to ∼11 nm (1100°C). The adsorption isotherms also show a change from Type IV to Type II with increase in temperature showing difference in surface properties. The information from t-plots, pore size distribution and cumulative pore volume data also indicates differences in porosity features of boehmite on calcination. The adsorption isotherm and pore size distribution analysis show maximum microporosity at 400°C, while maximum mesoporosity is observed at 600°C. At higher temperatures, porosity decreases, even though small fraction of pores in the mesopore range is still retained. At 1100°C, there is structural transformation from transitional to α-alumina, with very low specific surface area ∼5 m2/g and pores in the size range of 11 nm. The various data presented in this study will be useful in the synthesis of alumina with tailor made properties.

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Size-controlled synthesis of nano α-alumina particles through the sol–gel method

Synthesis of Aluminium Borate Nanowires by Sol–gel Method

Synthesis and characterization of sol–gel alumina nanofibers

A novel method for synthesis of Co–Al layered double hydroxides and their conversions to mesoporous CoAl 2 O 4 nanostructures for applications in adsorption removal of fluoride ions

A Novel Method To Synthesize Amorphous Silica−Alumina Materials with Mesoporous Distribution without Using Templates and Pore-Regulating Agents

A new route to synthesis of γ-alumina nanorods

Hydrothermal synthesis and characterization of core/shell ALOOH microspheres

Facile synthesis of nano-crystalline alpha-alumina at low temperature via an absolute ethanol sol-gel strategy

A Novel Sol–gel Synthetic Route to Alumina Nanofibers Via Aluminum Nitrate and Hexamethylenetetramine

Synthesis of γ-alumina via precipitation in ethanol

Adsorption Isotherm and Pore Characteristics of Nano Alumina Derived from Sol-Gel Boehmite

Hydrothermal synthesis of boehmite nanorods from alumina sols

Effect of the Way of Water Addition on the Morphology of Nano-Sized Al2O3 Powders Prepared by Sol-Gel Method

Tuning the structure of alumina

Preparation and Crystallization of Si-Al Gel

Synthesis of Al(OH)3Nanostructures from Al(OH)3Microagglomerates Via Dissolution-Precipitation Route

Ultrasonic Synthesis of Silica−Alumina Nanomaterials with Controlled Mesopore Distribution Without Using Surfactants

Preparation of Pseudo-Boehmite and Gamma-Al2o3 by Polyaluminum Chloride Ii -Surfactant Influences

Preparation Of Al2o3 Dense Films Using Sol Derived From Al(No3)(3)Center Dot 9h(2)O

The Fabrication of the Hydrous Alumina Powders by the Sol-Gel Method