Effect Of Sintering Process On Micro-structure And Properties Of Mullite Porous Ceramics Containing magnesium oxide

Yuxi Wang,Shaofeng Zhu,Xianzhi Zhou,Tong Zhang

DOI: https://doi.org/10.1088/1742-6596/2206/1/012037

2022-02-01

Journal of Physics: Conference Series

Abstract:Abstract Mullite porous ceramics with high porosity and good mechanical properties were prepared by foaming method combined with gel casting process using kaolin and alumina as main raw materials and sodium polyoxyethylene ether sulfate as foaming agent. The effects of sintering process and magnesium oxide content on the microstructure and properties of mullite porous ceramics were investigated. The studies show that: With the addition of magnesium oxide, the amount of mullite produced and the compactness of the sample will increase. At this time, the microscopic morphology of mullite is needle-like and prismatic, and the mechanical properties are better. and the pore size distribution gradually tends to be between 0.1-0.2mm and 0.2-0.3mm. The addition of magnesium oxide, The amount of mullite phase increased, the densification degree of the sample increased, and the acicular and prismatic mullite phases with good mechanical properties were mainly formed, and the porosity of mullite porous ceramics decreased and the compressive strength increased. The pore size distribution gradually tends to be between 0.1-0.2mm and 0.2-0.3mm. As the sintering temperature increases, the porosity of mullite porous ceramics decreases and the compressive strength increases. With the extension of the holding time, the amount of mullite phase generated increases, the porosity remains basically unchanged, and the compressive strength increases.