Abstract:The preparation of precursor sol is the first and crucial step in fabricating oxide fibers by the sol–gel method. In this study, different aluminum-silica sols were prepared by adjusting the alumina and silica source mixing procedure using aluminum carboxylate sol and tetraethoxysilane (TEOS) as the aluminum source and silicon source, respectively. Continuous alumina-mullite precursor fibers were obtained by dry spinning and the effects of alumina and silica source mixing procedure on the phase transition and microstructure evolution of alumina-mullite composite fibers were investigated. The results showed that the mullite formation temperature in the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was about 1300 °C, while it was 800 °C in the fibers obtained by mixing aluminum carboxylate sol and TEOS. In addition, the grain size of the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was significantly smaller than that obtained by mixing aluminum carboxylate sol and TEOS. The mechanism of this difference was that the aluminum-silica sol obtained by adding TEOS during the preparation of aluminum carboxylate sol was a diphasic sol, while the aluminum-silica sol obtained by adding TEOS in the prepared aluminum carboxylate sol was a monophasic sol.Graphical Abstract

Synthesis and Characterization of Rich Silica Mullite Fibers by Sol–Gel Method Using Aluminum Lactate and Silica Sol

Preparation of Mullite Fibers by Sol-Gel Process and Study of Their Morphology

Mullite Fibers Prepared by Sol-Gel Method Using Aluminum Chloride Aluminum Isopropoxide and Tetraethylorthosilicate

Fabrication of Homogeneous Mullite-Based Fiber Porous Ceramics with High Strength and Porosity

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Mullite Fibers Prepared from an Inorganic Sol–gel Precursor

Preparation of Mullite Fibres by Sol–gel Processes Using Aluminium Carboxylates and Tetraethylorthosilicate

Mullite Fibres Preparation by Aqueous Sol–gel Process and Activation Energy of Mullitization

Synthesis and characterization of sol-gel derived continuous spinning alumina based fibers with silica nano-powders

Preparation and Mullitization Kinetics of Mullite Fibres via Sol-Gel Process

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Effect of Magnesium Oxide on Preparation of Mullite Fibers Via Sol-Gel Method

Synthesis and Characterization of Electrospun Mullite Nanofibers

Mullite Fiber Prepared by Sol-Gel Method Using Low-Molecular-Weight Acids as Modifying Agents

Effect of silica sol on phase transition of alumina-mullite fibers

Preparation of Dense Mullite Ceramics through Gelcasting of Alumina Slurry Dispersed in Silica Sol

A novel aqueous gel-casting for fabricating Al2O3-bonded fibrous mullite ceramics

Preparation of mullite ceramics with equiaxial grains from powders synthesized by the sol-gel method

Preparation and Crystallization of Si-Al Gel

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

Synthesis and characterization of sol–gel alumina nanofibers