Abstract:In this study, the continuous alumina fibers reinforced alumina matrix (Al2O3/Al2O3) composites were fabricated through sol–gel method at a sintering temperature range of 900–1400 °C, and their mechanical properties were analyzed separately. To explore the effects of sintering temperature on mechanical properties of composites, the high temperature properties of fibers and matrix were studied in a comprehensive manner. Our results suggested that the composites fabricated at different temperatures exhibited two different fracture features (ductile fracture and brittle fracture). Besides, the 1100 °C fabricated composites possessed the highest flexural strength of nearly 150 MPa. Al2O3 fibers displayed excellent thermal stability, and did not undergo phase transition during the preparation process. However, the grain size of fibers increased dramatically at a sintering temperature of 1200 °C, which led to a significant decrease in the mechanical properties. In the meantime, the surface morphology of fibers became very uneven because of grain coarsening. Due to the phase transition from γ-Al2O3 to α-Al2O3 at 1200 °C, the elastic modulus and microhardness of matrix increased significantly. The higher sintering temperature not only intensified the matrix but also strengthened the interface bonding, thus making the composites prone to brittle fracture. In conclusion, the optimal temperature of composites preparation should be lower than 1200 °C.

Effect of silica sol on phase transition of alumina-mullite fibers

Effect Of Silica Sol On The Properties Of Alumina-Based Duplex Ceramic Cores

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Fabrication of Homogeneous Mullite-Based Fiber Porous Ceramics with High Strength and Porosity

THIS ARTICLE HAS BEEN RETRACTED Effect of Silica Sol on the Properties of Alumina‐Based Duplex Ceramic Cores

Effects of SiO2 Addition on Phase Transition and Microstructure Evolution of Alumina Fibers Prepared Using the Sol-Gel Method

Effect of residual carbon on the phase transformation and microstructure evolution of alumina-mullite fibers prepared by sol-gel method

Effect of silica sol on the properties of alumina-based ceramic core composites

EFFECTS OF SILICA SOL ON THE PROPERTIES OF CORUNDUM -MULLITE DUPLEX CERAMICS

Removal of hydroxyl groups and its influence on the microstructures evolution of alumina-mullite fibers fabricated by sol-gel process

Effect of heat‐treatment on the microstructure and room‐temperature mechanical properties of alumina–silica fiber

The oriented growth behavior of α-Al2O3 grains in alumina-mullite biphasic fibers

Effect of thermal exposure on the microstructure and strength of an alumina‐silica ceramic fiber

Effects of alumina sols on the sintering of α-alumina ceramics

Grain boundary segregation for enhancing the thermal stability of alumina-mullite diphasic fibers by La2O3 addition

Synthesis and Characterization of Rich Silica Mullite Fibers by Sol–Gel Method Using Aluminum Lactate and Silica Sol

Microstructure evolution and mechanical behavior of a mullite fiber heat‐treated from 1100 to 1300°C

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

Effects of sintering temperature on mechanical properties of alumina fiber reinforced alumina matrix composites