Removal of hydroxyl groups and its influence on the microstructures evolution of alumina-mullite fibers fabricated by sol-gel process

Qiang Liu,Juan Wang,Lingjiao Zhan,Chaozhong Wu,Wensheng Liu,Shuwei Yao,Yunzhu Ma

DOI: https://doi.org/10.1016/j.ceramint.2023.02.212

IF: 5.532

2023-06-01

Ceramics International

Abstract:Hydroxyl groups are essential groups in the preparation of alumina-mullite fibers by the sol-gel process, which contributes to the formation of spinnable precursor sol. In this work, the removal of hydroxyl groups during pyrolysis and sintering, and its effect on fibers phase transition and microstructural evolution were systematically studied. Five pyrolyzed alumina-mullite fibers samples with different hydroxyl groups content were obtained by adjusting the pyrolysis temperature or introducing water vapor. It was revealed that the removal of hydroxyl groups existed throughout the sintering process, mainly concentrated before 800 °C. The mullitization temperature of the pyrolyzed fibers with more hydroxyl groups was about 1300 °C, while that of pyrolyzed fibers with fewer hydroxyl groups was 700 °C. In addition, an appropriate amount of residual hydroxyl groups (13.3 wt%) was beneficial to obtain a dense fine-grained microstructure of the pyrolyzed fibers after sintering, and the tensile strength of the fibers was increased to 1.6 ± 0.22 GPa. Finally, the influence mechanism of different hydroxyl content on the alumina-mullite fibers was discussed.

materials science, ceramics