Abstract:Mullite whiskers were prepared using molten salt reaction. The resulting whiskers have been investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), thermogravimetric analysis (TG-DSC) and high resolution transmission electron microscopy (HRTEM). SEM studies showed that diameter of the mullite whiskers was in a range of 200 similar to 400 nm and their length was several microns. The analysis of HRTEM data revealed that the interplanar spacing was 0.539 nm, in accordance with the spacing of (110) crystal plane of mullite. As silica species was introduced into starting reactants, the combination reaction of mullite formation took place, gamma-Al2O3 was consumed and mullite whiskers grew continuously. The most important factor in controlling mullite formation is the decomposition reaction of aluminum sulfate, and alpha-Al2O3 is fabricated by thermal pyrolysis of aluminum sulfate at 900 degrees C in molten sodium sulfate system without silica species participating. According to the thermodynamic calculation, alpha-Al2O3 is a stable phase as the product of the decomposition of Al-2 (SO4)(3) in comparison to gamma-Al2O3, and mullite formation reaction is a spontaneous process in the whole temperature range. The decomposition reaction of aluminum sulfate was investigated by Kissinger-Akahira-Suno method with various heating rates (beta=5, 10 and 15 K center dot min(-1)), and the apparent activation energy (E-a) of reaction is 257.2 kJ center dot mol(-1).

Preparation and Mullitization Kinetics of Mullite Fibres via Sol-Gel Process

Preparation of Mullite Fibers by Sol-Gel Process and Study of Their Morphology

Mullite Fiber Prepared by Sol-Gel Method Using Low-Molecular-Weight Acids as Modifying Agents

Fabrication of Homogeneous Mullite-Based Fiber Porous Ceramics with High Strength and Porosity

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

The characteristics of spinnable mullite sol prepared by sol-gel method

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Synthesis and Characterization of Electrospun Mullite Nanofibers

Preparation of Nanocrystalline Mullite Contained Microspheres by Sol-gel Process in Oil-in-Water Emulsion

Preparation of Mullite Monoliths with Well-Defined Macropores and Mesostructured Skeletons Via the Sol–gel Process Accompanied by Phase Separation

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Preparation of mullite ceramics with equiaxial grains from powders synthesized by the sol-gel method

Research Development for the Fabrication of Inorganic Continuous Mullite Fiber

Preparation and Characterization of Mullite Whiskers from Different Silica Sources via Molten Salt Reaction

Fabrication of Mullite Powders by A Novel Processing

Preparation and Crystallization of Si-Al Gel

Solution blow spinning mass production of mullite nanofiber from environment friendly aqueous Al–Si solutions

Fabrication of Fine Mullite Powders by Heterogeneous Nucleation and Growth Processing

Preparation And High-Temperature Strengthening Of Tetragonal Zirconia Mullite Whisker Composites

Preparation of YIG Single Crystal Nanofibers Via an Electrospinning Technique

Analysis of Factors Affecting the Preparation of Mullite Whiskers from Silica-Rich Slag and Application Studies