Abstract:AlN thin films were deposited on flexible Hastelloy tapes and Si (100) substrate by middle-frequency magnetron sputtering. A layer of Y2O3 films was used as a buffer layer for the Hastelloy tapes. A two-step deposition technique was used to prepare the AlN films. The effects of deposition parameters such as sputtering power, N2/Ar flow rate and sputtering pressure on the microstructure of the AlN thin films were systematically investigated. The results show that the dependency of the full width at half maximum (FWHM) of AlN/Y2O3/Hastelloy on the sputtering parameters is similar to that of AlN/Si (100). The FWHM of the AlN (002) peak of the prepared AlN films decreases with increasing sputtering power. The FWHM decreases with the increase of the N2/Ar flow rate or sputtering pressure, and increases with the further increase of the N2/Ar flow rate or sputtering pressure. The FWHM of the AlN/Y2O3/Hastelloy prepared under optimized parameters is only 3.7° and its root mean square (RMS) roughness is 5.46 nm. Based on the experimental results, the growth mechanism of AlN thin films prepared by the two-step deposition process was explored. This work would assist us in understanding the AlN film’s growth mechanism of the two-step deposition process, preparing highly c-axis–oriented AlN films on flexible metal tapes and developing flexible surface acoustic wave (SAW) sensors from an application perspective.

Preparation of Highly C-Axis Oriented AlN Thin Films on Hastelloy Tapes with Y2O3 Buffer Layer for Flexible SAW Sensor Applications

Sputtering Growth of Preferential C-Axis-oriented Aluminum Nitride Film Using Homogeneous Buffer Layer

Preparation Technique Of Aln Piezoelectric Thin Film

Effects of Sputtering Parameters on AlN Film Growth on Flexible Hastelloy Tapes by Two-Step Deposition Technique

Flexible Surface Acoustic Wave Device with Aln Film on Polymer Substrate

Preparation of Aln Thin Films for Film Bulk Acoustic Resonator Application by Radio Frequency Sputtering

Study of preparation of AlN Thin Films for FBAR Application by RF Sputtering

Enhancement of c-Axis Oriented Aluminum Nitride Films via Low Temperature DC Sputtering

Study on c-axis orientation of AlN thin film on the influence Al buffer layer and Ar/N2 gas flow ratio in reactive magnetron sputtering

Growth and Characterization of Polyimide-Supported AlN Films for Flexible Surface Acoustic Wave Devices

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Study on optimizing c-axis oriented AlN thin film for piezoelectric sensing applications controlling the sputtering process parameters

Effects of AlN Coating Layer on High Temperature Characteristics of Langasite SAW Sensors

Deposition of c-axis orientation aluminum nitride films on flexible polymer substrates by reactive direct-current magnetron sputtering

Optical properties and hardness of highly a-axis oriented AlN films

Pt thin-film resistance temperature detector on flexible Hastelloy tapes

Deposition of c-axis orientation aluminum nitride films on flexible polymer substrates by reactive DC magnetron sputtering

Growth of C-Axis Oriented Aln Thin Films on Titanium Alloy Substrate by Middle Frequency Magnetron Sputtering

High Potential Columnar Nanocrystalline AlN Films Deposited by RF Reactive Magnetron Sputtering

Preparation and Properties of C-axis Preferred Orientation AlN Thin Films by Pure Nitrogen Reactive Sputtering

Novel AlN/Pt/ZnO Electrode for High Temperature SAW Sensors.