Abstract:The higher voltage blocking capability and faster switching speed of silicon-carbide (SiC) mosfets have the potential to replace Si insulated gate bipolar transistors (IGBTs) in medium-low-voltage and high-power applications. In this paper, a state-of-the-art commercially available 325 A, 1700 V SiC mosfet module has been fully characterized under various load currents, bus voltages, and gate resistors to reveal their switching capability. Meanwhile, Si IGBT modules with similar power ratings are also tested under the same conditions. From the test results, several interesting points have been obtained: different to the Si IGBT module, the over-shoot current of the SiC mosfet module increases linearly with the increase of the load current and it has been explained by a model of the over-shoot current proposed in this paper; the induced negative gate voltage due to the complementary device turn-off (crosstalk effect) is more harmful to the SiC mosfet module than the induced positive gate voltage during turn-on when the gate off-voltage is 6 V; the maximum dvdt and didt (electromagnetic interference) during switching transients of the SiC mosfet module are close to those of the Si IGBT module when the gate resistance is larger than 8 but the switching loss of the SiC mosfet module is much smaller; the switching losses of the Si IGBT module are greater than those of the SiC mosfet module even when the gate resistance of the former is reduced to zero. An accurate power loss model, which is suitable for a three-phase two-level converter based on SiC mosfet modules considering the power loss of the parasitic capacitance, has been presented and verified in this paper. From the model, a 96.2 efficiency can be achieved at the switching frequency of 80kHz and the power of 100 kW.

Fabrication and Testing of 4 500 V SiC SBD and JFET Power Modules

Fabrication and testing of 3500V/15A SiC JFET based power module for high-voltage, high-frequency applications

Fabrication and Dynamic Switching Characteristics of 6.5kv400a SiC MOSFET Module

Design and Application of High-Voltage SiC JFET and Its Power Modules

High-voltage full-SiC power module: Device fabrication, testing and high frequency application in kW-level converter

Dynamic Performance of 6.5kV/400A SiC MOSFET Module and its Gate Driver

Development of 3 300 V SiC SBD and Hybrid Power Module

A Double-Sided Cooling 6.5kv SiC MOSFET Power Module with Insulation Enhancement Design

1700 V full-SiC half-bridge power module with low switching loss

High Temperature Characterization Of 4h-Sic Normally-On Vertical Jfets With Buried Gate And Buried Field Rings

Design and Evaluation of a 1200-V/200-A SiC Three-Level NPC Power Module

An Indirect Series-Connected SiC MOSFET Power Module with Voltage Self-Balance

Development of High-Voltage SiC Power Electronic Devices

Compact-Interleaved Packaging Method of Power Module With Dynamic Characterization of 4H-SiC MOSFET and Development of Power Electronic Converter at Extremely High Junction Temperature

Modeling and Design of a Monolithically Integrated Power Converter on SiC

Investigation of Low-Profile, High-Performance 62-mm SiC Power Module Package

Performance Evaluation of High-Power SiC MOSFET Modules in Comparison to Si IGBT Modules

Design, Packaging and Evaluation of an All-SiC-Based Four-Level ANPC Power Module

Comparative Evaluation of 10 Kv SiC MOSFET Power Module Insulation Ability Through Chip Neighborhood Range Electric Field Modelling