Abstract:This paper reports an enhancement of the nonlinear conductivity, thermal and mechanical properties of micro-silicon carbide/silicone elastomer (m-SiC/SE) composites by adding nano-aluminum nitride (n-AlN) for power module encapsulation applications. The electrical properties (such as nonlinear conductivity characteristics and transient permittivity obtained from polarization current, and trap distributions obtained from thermally stimulated depolarization current) and material properties (including thermo-gravimetric analysis, coefficient of thermal expansion (CTE), and thermal conductivity, tensile strength, strain at break and Young's modulus) of the pure SE, m-SiC/SE microcomposites, m-SiC/n-AlN/SE hybrid composites are investigated. The effect of the m-SiC fillers and n-AlN fillers on physicochemical properties of the SE matrix is analyzed by FT-IR spectroscopy and crosslinking degree. The measured nonlinear conductivity and transient permittivity are used for electric field simulation under DC stationary and square voltages. It is found that the addition of n-AlN fillers in the SE hybrid composite improves the nonlinear conductivity characteristics and mitigates the electric field under DC stationary and square voltages, compared to the SE microcomposite. Furthermore, the m-SiC/n-AlN/SE hybrid composite has a higher thermal degradation temperature, thermal conductivity, tensile strength, Young's modulus, and crosslinking degree than the SE microcomposite, whereas their CTE and strain at break are lower. It is elucidated that the m-SiC/n-AlN/SE hybrid composite with enhanced nonlinear conductivity and material properties is a promising packaging material for high-voltage power modules.

Novel Polymer Substrate-Based 1.2 Kv/40 A Double-Sided Intelligent Power Module

Flexible Epoxy Resin Substrate Based 1.2 Kv SiC Half Bridge Module with Ultra-low Parasitics and High Functionality

Investigation of Low-Profile, High-Performance 62-mm SiC Power Module Package

Enhanced Field-Dependent Conductivity and Material Properties of Nano-Aln/micro-sic/silicone Elastomer Hybrid Composites for Electric Stress Mitigation in High-Voltage Power Modules

1700 V full-SiC half-bridge power module with low switching loss

Fabrication and Dynamic Switching Characteristics of 6.5kv400a SiC MOSFET Module

A SiC Double-Sided Stacked Wire-Bondless Power Module for High-Frequency Power Electronic Applications

A Double-Side Cooled SiC MOSFET Power Module With Sintered-Silver Interposers: I-Design, Simulation, Fabrication, and Performance Characterization

Thermal and Reliability Characterization of an Epoxy Resin-Based Double-Side Cooled Power Module

High Temperature Direct Double Side Cooled Inverter Module for Hybrid Electric Vehicle Application

Dynamic Performance of 6.5kV/400A SiC MOSFET Module and its Gate Driver

Fan-Out Panel-Level PCB-Embedded SiC Power MOSFETs Packaging

10-kV SiC MOSFET Power Module With Reduced Common-Mode Noise and Electric Field

A Wire-Bondless Packaging Platform for Silicon Carbide Power Semiconductor Devices

A GaN HEMT Integrated Power Module with Silver Sintering Processes

A Novel SiC MOSFET Module for High-power Soft-switching Converter

Compact Sandwiched Press-Pack SiC Power Module With Low Stray Inductance and Balanced Thermal Stress

Characterization of a Bare-die SiC-based, Wirebond-less, Integrated Half-bridge with Multi-functional Bus-Bars

Design of a Novel Double Sided Cooling SiC Power Module Based on Multiple DBC-Stacked

Low Parasitic-Inductance Packaging of a 650 V/150 A Half-Bridge Module Using Enhancement-Mode Gallium-Nitride High Electron Mobility Transistors