Abstract:Planar, double-side cooled power modules are emerging in electric-drive inverters because of their low profile, better heat extraction, and lower package parasitic inductances. However, there is still a concern about their reliability due to the rigid interconnection between the device chips and two substrates of the power module. In this article, a porous interposer made of low-temperature sintered silver is introduced to reduce the thermomechanical stresses in the module. A double-side cooled half-bridge module consisting of two 1200 V, 149 A SiC MOSFETs was designed, fabricated, and characterized. By using the sintered-Ag instead of solid copper interposers, our simulation results showed that, at a total power loss of 200 W, the thermomechanical stress at the most vulnerable interfaces (interposer-attach layer) was reduced by 42% and in the SiC MOSFET by 50% with a tradeoff of only 3.6% increase in junction temperature. The sintered-Ag interposers were readily fabricated into the desired dimensions without postmachining and did not require any surface finishing for die bonding and substrate interconnection by silver sintering. The porous interposers were also deformable under a low force or pressure, which helped to accommodate chip thickness and/or substrate-to-substrate gap variations in the planar module structure, thus simplifying module fabrication. The experimental results on the electrical performance of the fabricated SiC modules validated the success of using the porous silver interposers for fabricating planar, double-side cooled power modules.

A Novel SiC MOSFET Module for High-power Soft-switching Converter

Design of Low Parasitic Inductance SiC MOSFETs Halfbridge Power Modules

A Highly Integrated Multichip SiC MOSFET Power Module With Optimized Electrical and Thermal Performances

Analysis of A Low-Inductance Packaging Layout for Full-Sic Power Module Embedding Split Damping

Design and evaluation of press-pack SiC MOSFET

A Quasi-Two-Level Medium-Voltage SiC MOSFET Power Module with Low Loss and Voltage Self-Balance

Fan-Out Panel-Level PCB-Embedded SiC Power MOSFETs Packaging

An Improved SiC MOSFET-gate Driver Integrated Power Module with Ultra Low Stray Inductances

A Novel Double-sided Cooling 3L-ANPC SiC MOSFET Power Module with Interleaved Layout

A Solution to Press-Pack Packaging of SiC MOSFETS

A Low-Inductance Packaging Layout for 1.2kv, 40A Full-SiC Power Module Embedding Split Damping Capacitors

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Fabrication and Dynamic Switching Characteristics of 6.5kv400a SiC MOSFET Module

Design of a High-power Density Power Module with Large-area (10 Mm × 10 Mm) SiC MOSFETs for Traction Inverter Application

A Double-Side Cooled SiC MOSFET Power Module With Sintered-Silver Interposers: I-Design, Simulation, Fabrication, and Performance Characterization

Analysis on Ultra-Fast Switching of SiC MOSFETs for Megahertz Applications Enabled by 3D Package and Embedded Components

Design of a 10 kV SiC MOSFET-based high-density, high-efficiency, modular medium-voltage power converter

Design and Application of A 1200v Ultra-Fast Integrated Silicon Carbide Mosfet Module

An Indirect Series-Connected SiC MOSFET Power Module with Voltage Self-Balance

A Simple Structure of Auxiliary Resonant Commutated Pole SiC-Based Soft-Switching Inverter

Innovative Reverse Current Coupling Layout of SiC Power Module for Parasitic Inductance Reduction