Abstract:One challenge of on board charger application is bi-directional operation. Due to the absence of reverse recovery charge and small junction capacitance, it is much easier to do bi-directional operation using wide band gap devices. Another challenge is the very wide battery voltage range. It is very difficult to optimize converter over the whole battery voltage range and efficiency drops either the battery voltage is too high or too low. In this paper, a novel two stage structure is proposed utilizing both SiC and GaN devices. Bi-directional power flow as well as zero voltage switching is achieved with the proposed structure. In addition, a variable DC-link voltage operation is adopted to deal with the wide battery voltage range so that the CLLC resonant converter can always work at its optimized point. Design considerations of the two stage on-board charger are introduced, including system structure evaluation, resonant converter design and control strategy. A 6.6kW on board charger prototype with 500kHz (300kH for AC/DC stage) switching frequency is demonstrated with 43W/in(3) power density and above 96% efficiency over the whole battery voltage range.

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

Design of CRM AC/DC Converter for Very High-Frequency High-Density WBG-based 6.6kw Bidirectional On-Board Battery Charger

Bi-directional On-Board Charger Architecture and Control for Achieving Ultra-High Efficiency with Wide Battery Voltage Range

High-Efficiency High-Density Critical Mode Rectifier/Inverter for WBG-Device-Based On-Board Charger

A High-Efficiency High-Density Wide-Bandgap Device-Based Bidirectional On-Board Charger

A High Efficiency Two-Stage ZVS AC/DC Converter with All SiC MOSFET

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Hybrid SiC-Si DC–AC Topology: SHEPWM Si-IGBT Master Unit Handling High Power Integrated with Partial-Power SiC-MOSFET Slave Unit Improving Performance

Design of a 300 Kw Partial Power Processing Based DC-DC Converter for Electric Vehicles Extreme Fast Charging Stations

An Integrated Design of Power Converters for Electric Vehicles.

High Power Three-Level Rectifier Comprising SiC MOSFET & Si Diode Hybrid Power Stage

An Extremely High Efficient Three-Level Active Neutral-Point-Clamped Converter Comprising SiC and Si Hybrid Power Stages

A High Power Density 3-Phase/1-phase Compatible MISN-PFC Converter for On-Board Charger

Three Phase PFC Converter with Multilevel Inductive Switching Network

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

A Three-Phase-Module-Parallel Si & SiC Hybrid Inverter with Smaller Filter Size and Low Cost

High efficiency power factor correction power supply based on SiC device

A Novel SiC MOSFET Module for High-power Soft-switching Converter

Single Phase High Power Density MISN PFC Converter

A Design of High-power Buck Converter Based on Synchronous Rectification