Abstract:This paper proposes a novel integrated power system for electric vehicles (EVs) to improve the power density and efficiency at a less cost. It integrates the on-board charger (OBC) and the low-voltage DC/DC converter (LDC) by common use of semiconductor devices, capacitors and magnetic components. Therefore, the volume and cost of the integrated system is reduced compared with the conventional two independent converters. The proposed system can operate in three modes: OBC standalone mode, LDC standalone mode and OBC-LDC simultaneous mode. The phase-shift control is the main control strategy for this system. For a light load, a PWM plus phase shift (PPS) control is added to provide expending soft switching range. As the most important integrated component, the transformer is designed by considering the soft switching ranges. The theoretical analysis of topology, operating modes, control strategy and transformer design are presented. A prototype integrating a 3.3-kW OBC and a 2-kW LDC is built to demonstrate the validity and advantages of the proposed system.

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Design and Simulation of a PFM-PWM Hybrid Controller for DCDC Converter with CLLC Topology

A Five-Level Converter Interfacing Medium-Voltage

An Integrated Design of Power Converters for Electric Vehicles.

An Extremely High Efficient Three-Level Active Neutral-Point-Clamped Converter Comprising SiC and Si Hybrid Power Stages

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

Three Phase PFC Converter with Multilevel Inductive Switching Network

A Novel Single-Stage Five-Level Common-Ground-Boost-Type Active Neutral-Point-Clamped (5L-CGBT-ANPC) Inverter

A High Power Density 3-Phase/1-phase Compatible MISN-PFC Converter for On-Board Charger

A novel three-phase seven-level active clamped converter using H-bridge as a level doubling network

Study And Design Of Noninductive Bus Bar For High Power Switching Converter

Topology and Control of a Five-Level Hybrid-Clamped Converter for Medium-Voltage High-Power Conversions

Single Phase High Power Density MISN PFC Converter

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Investigation of Hybrid Three-Level Hybrid Device (Hybrid<sub>2</sub>) Active Neutral-Point-Clamped Converter

Investigation of Hybrid Three-Level Hybrid Device (Hybrid<inf>2</inf>) Active Neutral-Point-Clamped Converter

Analysis Of Hybrid Cascaded Multilevel Converter Based Statcom

Engineering Design for Structure and Bus Bar of 1.2MV·A Hybrid Clamped Five-Level Converter Module

A New Five-Level Hybrid-Clamped Converter with Reduced Number of Clamping Devices

Capacitor Voltage Balancing of a Five-Level ANPC Converter Using Phase-Shifted PWM

Engineering design for structure and bus bar of 1.2MVA hybrid clamped five-level converter module