Abstract:Planar, double-side cooled power modules are emerging in electric-drive inverters because of their low profile, better heat extraction, and lower package parasitic inductances. However, there is still a concern about their reliability due to the rigid interconnection between the device chips and two substrates of the power module. In this article, a porous interposer made of low-temperature sintered silver is introduced to reduce the thermomechanical stresses in the module. A double-side cooled half-bridge module consisting of two 1200 V, 149 A SiC MOSFETs was designed, fabricated, and characterized. By using the sintered-Ag instead of solid copper interposers, our simulation results showed that, at a total power loss of 200 W, the thermomechanical stress at the most vulnerable interfaces (interposer-attach layer) was reduced by 42% and in the SiC MOSFET by 50% with a tradeoff of only 3.6% increase in junction temperature. The sintered-Ag interposers were readily fabricated into the desired dimensions without postmachining and did not require any surface finishing for die bonding and substrate interconnection by silver sintering. The porous interposers were also deformable under a low force or pressure, which helped to accommodate chip thickness and/or substrate-to-substrate gap variations in the planar module structure, thus simplifying module fabrication. The experimental results on the electrical performance of the fabricated SiC modules validated the success of using the porous silver interposers for fabricating planar, double-side cooled power modules.

Design of a Novel Double Sided Cooling SiC Power Module Based on Multiple DBC-Stacked

A Novel Multiple DBC-staked Units Package to Parallel More Chips for SiC Power Module

High performance cooling system for automotive inverters

A Novel Double-sided Cooling 3L-ANPC SiC MOSFET Power Module with Interleaved Layout

A SiC Double-Sided Stacked Wire-Bondless Power Module for High-Frequency Power Electronic Applications

Multichip Parallel Double-Sided Cooling Silicon Carbide Power Module With Low Parasitic Inductance and Balanced Dynamic Current

Design Method for Multichip Double-Sided Cooling Power Module with Multidimensional Self-and Mutual Inductances

Design of a High-power Density Power Module with Large-area (10 Mm × 10 Mm) SiC MOSFETs for Traction Inverter Application

Electrothermal Analysis of a Double-side Cooling Power Module with Large-area SiC MOSFETs

High Temperature Direct Double Side Cooled Inverter Module for Hybrid Electric Vehicle Application

A Double-Sided Cooling 6.5kv SiC MOSFET Power Module with Insulation Enhancement Design

Interleaved Planar Packaging Method of Multichip SiC Power Module for Thermal and Electrical Performance Improvement

High power SiC inverter module packaging solutions for junction temperature over 220°C

A Double-Side Cooled SiC MOSFET Power Module With Sintered-Silver Interposers: I-Design, Simulation, Fabrication, and Performance Characterization

A Highly Integrated Multichip SiC MOSFET Power Module With Optimized Electrical and Thermal Performances

A Novel SiC MOSFET Module for High-power Soft-switching Converter

A Double-sided Flip chip SiC Power Module with a Novel Flip Chip Method On DBC By PTFE Coating

A Double-sided Cooled Power Module with Embedded Decoupling Capacitors

Compact Sandwiched Press-Pack SiC Power Module With Low Stray Inductance and Balanced Thermal Stress

Performance Optimization of A 1.2kv SiC High Density Half Bridge Power Module in 3D Package

Investigation of Low-Profile, High-Performance 62-mm SiC Power Module Package