Abstract:As the enhanced acceleration performance of electric vehicles demands improved mileage capabilities, 3D packaging is a promising solution for developing high-power-density SiC power modules. However, 3D pack-aging causes instability owing to the increased heat flux and heat dissipation inside the power module. Thus, this paper proposes an ultra-thermostable embedded liquid cooling strategy for the thermal management of SiC 3D packaging power modules in electric vehicles. We constructed an embedded micro pin-fin (E-MPF) with non-uniform density in the SiC substrate to mount the SiC Schottky barrier diodes (SBDs). The thermostability and temperature uniformity of the SiC 3D packaging power modules containing E-MPF SiC and direct bond copper (DBC) substrates were verified. The results revealed that the SiC SBDs mounted on the E-MPF SiC substrate could stably operate up to a total power dissipation of 320 W at a 100 mL/min coolant (water) flow rate, whereas those attached on the DBC substrate could be operated only under 144 W (operation terminated at a maximum junction temperature of 175 celcius). Furthermore, the junction-to-coolant thermal resistance of the E-MPF SiC substrate could be reduced by 78.89 % compared to that of the DBC substrate. Moreover, the prepared 3D stacking package effectively improved the temperature uniformity of the SiC power modules by 68.69 %. The presented ultra-thermostable E-MPF substrate SiC power module can steadily render a motor torque elevation that is one magnitude greater than that required for sustaining the boiling-free condition on the DBC substrate. This embedded liquid-cooling architecture affords a feasible solution for the thermal management of upcoming high-power electric vehicle SiC inverters.

Direct Integration of Optimized Phase-Change Heat Spreaders Into SiC Power Module for Thermal Performance Improvements Under High Heat Flux

Directly Integrated Vapor Chamber as an Efficient Heat Spreader for High Heat Flux Density SiC MOSFET Dies in Power Modules

Comparative Study of Thermal Performance of a SiC MOSFET Power Module Integrated with Vapor Chamber for Traction Inverter Applications

Heat spreading performance of SiC-based power module with bonded vapour chamber for electric powertrain integration

Interleaved Planar Packaging Method of Multichip SiC Power Module for Thermal and Electrical Performance Improvement

A Highly Integrated Multichip SiC MOSFET Power Module With Optimized Electrical and Thermal Performances

Investigation of Low-Profile, High-Performance 62-mm SiC Power Module Package

Compact-Interleaved Packaging Method of Power Module With Dynamic Characterization of 4H-SiC MOSFET and Development of Power Electronic Converter at Extremely High Junction Temperature

A SiC Double-Sided Stacked Wire-Bondless Power Module for High-Frequency Power Electronic Applications

An Evaluation on Thermal Performance Improvements for SiC Power Module Integrated with Vapor Chamber in MMC

Ultra-thermostable Embedded Liquid Cooling in SiC 3D Packaging Power Modules of Electric Vehicles

High Temperature Direct Double Side Cooled Inverter Module for Hybrid Electric Vehicle Application

A Solution to Press-Pack Packaging of SiC MOSFETS

A Double-Side Cooled SiC MOSFET Power Module With Sintered-Silver Interposers: I-Design, Simulation, Fabrication, and Performance Characterization

Fan-Out Panel-Level PCB-Embedded SiC Power MOSFETs Packaging

Design Method for Multichip Double-Sided Cooling Power Module with Multidimensional Self-and Mutual Inductances

High power SiC inverter module packaging solutions for junction temperature over 220°C

Analysis of Novel Packaging Techniques for High Power Electronics in SiC

Direct Phase-Change Cooling of Vapor Chamber Integrated With IGBT Power Electronic Module for Automotive Application

Electrothermal Analysis of a Double-side Cooling Power Module with Large-area SiC MOSFETs

Understanding the Thermal Characteristics of SiC Power MOSFET Device for Power Modules Design