Abstract:As the enhanced acceleration performance of electric vehicles demands improved mileage capabilities, 3D packaging is a promising solution for developing high-power-density SiC power modules. However, 3D pack-aging causes instability owing to the increased heat flux and heat dissipation inside the power module. Thus, this paper proposes an ultra-thermostable embedded liquid cooling strategy for the thermal management of SiC 3D packaging power modules in electric vehicles. We constructed an embedded micro pin-fin (E-MPF) with non-uniform density in the SiC substrate to mount the SiC Schottky barrier diodes (SBDs). The thermostability and temperature uniformity of the SiC 3D packaging power modules containing E-MPF SiC and direct bond copper (DBC) substrates were verified. The results revealed that the SiC SBDs mounted on the E-MPF SiC substrate could stably operate up to a total power dissipation of 320 W at a 100 mL/min coolant (water) flow rate, whereas those attached on the DBC substrate could be operated only under 144 W (operation terminated at a maximum junction temperature of 175 celcius). Furthermore, the junction-to-coolant thermal resistance of the E-MPF SiC substrate could be reduced by 78.89 % compared to that of the DBC substrate. Moreover, the prepared 3D stacking package effectively improved the temperature uniformity of the SiC power modules by 68.69 %. The presented ultra-thermostable E-MPF substrate SiC power module can steadily render a motor torque elevation that is one magnitude greater than that required for sustaining the boiling-free condition on the DBC substrate. This embedded liquid-cooling architecture affords a feasible solution for the thermal management of upcoming high-power electric vehicle SiC inverters.

High performance cooling system for automotive inverters

High Temperature Direct Double Side Cooled Inverter Module for Hybrid Electric Vehicle Application

Compact Inverter Designed for High-Temperature Operation

Design of a Novel Double Sided Cooling SiC Power Module Based on Multiple DBC-Stacked

High power SiC inverter module packaging solutions for junction temperature over 220°C

An Innovative Additively Manufactured Design Concept of a Dual-Sided Cooling System for SiC Automotive Inverters

Direct Metallization-Based DBC-Free Power Modules for Near-Junction Water Cooling: Analysis and Experimental Comparison

Direct Phase-Change Cooling of Vapor Chamber Integrated With IGBT Power Electronic Module for Automotive Application

Addressing Thermal Management Concerns for a Power Electronics Module Using an Integrated Micro-Cooling Chip Array Scheme

A Double-sided Cooled Power Module with Embedded Decoupling Capacitors

Design of High Efficiency Inverter with Air Cooling for Electric Vehicle

Ultra-thermostable Embedded Liquid Cooling in SiC 3D Packaging Power Modules of Electric Vehicles

Investigation of Vehicle-Oriented Double-Sided Cooling Power Module With BGA Technology

A Double-Side Cooled SiC MOSFET Power Module With Sintered-Silver Interposers: I-Design, Simulation, Fabrication, and Performance Characterization

Liquid Cooling System for a High Power, Medium Frequency, and Medium Voltage Isolated Power Converter

Electrothermal Analysis of a Double-side Cooling Power Module with Large-area SiC MOSFETs

Design of a High-power Density Power Module with Large-area (10 Mm × 10 Mm) SiC MOSFETs for Traction Inverter Application

Reliability design of direct liquid cooled power semiconductor module for hybrid and electric vehicles

Coolers Based on Semiconductor Refrigeration Technology for Electric Vehicle On-Board Chargers

A Thorough Review of Cooling Concepts and Thermal Management Techniques for Automotive WBG Inverters: Topology, Technology and Integration Level

Design Method for Multichip Double-Sided Cooling Power Module with Multidimensional Self-and Mutual Inductances