Abstract:This paper reports a novel capacitive accelerometer with highly symmetrical double-sided beam-mass structure. The highly symmetrical structure is fabricated from single wafer by a novel vertical sidewall protection technique. The good device performance is obtained by highly symmetrical double-sided beam-mass structure and fabrication process that enable formation of a large proof mass, controllable thickness of beam, and a narrow uniform capacitive gap over a large area. The resonance frequency of the accelerometer is measured in open loop system by a network analyzer. The quality factor and the resonant frequency are 34 and 787Hz, respectively. The accelerometer with closed loop interface circuit is calibrated on B&K Vibration Transducer Calibration System (Type 3629). The typical measurement range of the device is 1g, and the maximum range is 2g. The capacitance sensitivity of the fabricated accelerometer is 11.7pF/g. The sensitivity of the device with closed loop interface circuit is 1V/g, and the nonlinearity is 0.39% over the range of 1g. The cross-sensitivity x/z is 0.72% and y/z is 0.50%, respectively. The accelerometer with closed loop circuit has wide bandwidth of DC to 1kHz (3dB). Also the bias stability is 255μg. The device with closed loop circuit has signal to noise ratio (SNR) of 106dB, the average noise floor is 3.1μg/Hz (0–100Hz).

A Novel Accelerometer On (111) Substrate With Differential Electrode

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

A novel (111) single-crystal-silicon accelerometer using parallel-connected parallel plate capacitance

Study of a Novel Micromachined Capacitive Accelerometer

A Novel Scheme Design of a High-G Optical NEMS Accelerometer Based on a Single Chip Grating with Proper Sensitivity and Large Bandwidth

A novel capacitive accelerometer with an eight-beam-mass structure by self-stop anisotropic etching of (1 0 0) silicon

A novel sandwich capacitive accelerometer with a symmetrical structure fabricated from a D-SOI wafer

A Novel Soi Z-axis Accelerometer with Gap Closing Differential Sensing Electrodes

A New Symmetrical Beam-Mass Structure for Accelerometers by Anisotropic Etching Without Convex Corner Compensation

A Novel Z-Axis Capacitance Accelerometer with Highly Symmetrical 16-Beam Structure

A Novel Micro-Machined Out-of-Plane Resonant Accelerometer with Differential Structure of Different-Height Resonant Beams

A novel SOI-based single proof-mass 3-axis accelerometer with gap-closing differential capacitive electrodes in all sensing directions

A Novel Sandwich Capacitive Accelerometer with A Double-Sided 16-Beam-mass Structure

Compact electrode design for in-plane accelerometer on SOI with refilled isolation trench

The Design and Fabrication of A Miniaturized Differential-Capacitive Triaxial Accelerometer

A MEMS Sandwich Differential Capacitive Silicon-on-insulator Accelerometer

A novel out-of-plane MEMS tunneling accelerometer

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

A Novel Capacitive Accelerometer with A Highly Symmetrical Double-Sided Beam-Mass Structure

Design and Fabrication of a Mems Capacitive Accelerometer Based on Double-Device-layers SOI Wafer.

Fabrication of a MEMS Capacitive Accelerometer with Symmetrical Double-Sided Serpentine Beam-Mass Structure