Abstract:This paper reports a novel capacitive accelerometer with highly symmetrical double-sided beam-mass structure. The highly symmetrical structure is fabricated from single wafer by a novel vertical sidewall protection technique. The good device performance is obtained by highly symmetrical double-sided beam-mass structure and fabrication process that enable formation of a large proof mass, controllable thickness of beam, and a narrow uniform capacitive gap over a large area. The resonance frequency of the accelerometer is measured in open loop system by a network analyzer. The quality factor and the resonant frequency are 34 and 787Hz, respectively. The accelerometer with closed loop interface circuit is calibrated on B&K Vibration Transducer Calibration System (Type 3629). The typical measurement range of the device is 1g, and the maximum range is 2g. The capacitance sensitivity of the fabricated accelerometer is 11.7pF/g. The sensitivity of the device with closed loop interface circuit is 1V/g, and the nonlinearity is 0.39% over the range of 1g. The cross-sensitivity x/z is 0.72% and y/z is 0.50%, respectively. The accelerometer with closed loop circuit has wide bandwidth of DC to 1kHz (3dB). Also the bias stability is 255μg. The device with closed loop circuit has signal to noise ratio (SNR) of 106dB, the average noise floor is 3.1μg/Hz (0–100Hz).

A novel (111) single-crystal-silicon accelerometer using parallel-connected parallel plate capacitance

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

Study of a Novel Micromachined Capacitive Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

A Novel Accelerometer On (111) Substrate With Differential Electrode

Design and Virtual Fabrication Process of a New Kind of Capacitive Accelerometer

A novel capacitive accelerometer with an eight-beam-mass structure by self-stop anisotropic etching of (1 0 0) silicon

A novel sandwich capacitive accelerometer with a symmetrical structure fabricated from a D-SOI wafer

A Novel Capacitive Accelerometer with A Highly Symmetrical Double-Sided Beam-Mass Structure

High Resolution Single Crystal Silicon Accelerometer Using Silicon Fusion Bonding and Deep Reactive Ion Etching

A Novel Z-Axis Capacitance Accelerometer with Highly Symmetrical 16-Beam Structure

Modeling and Analysis of a SiC Microstructure-Based Capacitive Micro-Accelerometer

A Highly Symmetrical Capacitive Accelerometer by Silicon Four-Layer Bonding

Design and Fabrication Research on a Capacitive Accelerometer

High-Performance Single-Side Fabricated (111)-Silicon Dual-Cantilever Accelerometer with Squeeze-Film Air Damping Modulation

Piezoresistive Slot-Cantilever Type Accelerometer Inspired from Spider'S Slit Sensilla

A silicon-on-glass Z-axis accelerometer with vertical sensing comb capacitors.

A Novel Soi Z-axis Accelerometer with Gap Closing Differential Sensing Electrodes

Design and Fabrication of a Highly Symmetrical Capacitive Triaxial Accelerometer

A Novel Sandwich Capacitive Accelerometer with A Double-Sided 16-Beam-mass Structure

Fabrication of a MEMS Capacitive Accelerometer with Symmetrical Double-Sided Serpentine Beam-Mass Structure