Abstract:The comb capacitances fabricated by deep reactive ion etching (RIE) process have high aspect ratio which is usually smaller than 30: 1 for the complicated process factors, and the combs are usually not parallel due to the well-known micro-loading effect and other process factors, which restricts the increase of the seismic mass by increasing the thickness of comb to reduce the thermal mechanical noise and the decrease of the gap of the comb capacitances for increasing the sensitive capacitance to reduce the electrical noise. Aiming at the disadvantage of the deep RIE, a novel capacitive micro-accelerometer with grid strip capacitances and sensing gap alterable capacitances is developed. One part of sensing of inertial signal of the micro-accelerometer is by the grid strip capacitances whose overlapping area is variable and which do not have the non-parallel plate's effect caused by the deep RIE process. Another part is by the sensing gap alterable capacitances whose gap between combs can be reduced by the actuators. The designed initial gap of the alterable comb capacitances is relatively large to depress the effect of the maximum aspect ratio (30 : 1) of deep RIE process. The initial gap of the capacitance of the actuator is smaller than the one of the comb capacitances. The difference between the two gaps is the initial gap of the sensitive capacitor. The designed structure depresses greatly the requirement of deep RIE process. The effects of non-parallel combs on the accelerometer are also analyzed. The characteristics of the micro-accelerometer are discussed by field emission microscopy (FEM) tool ANSYS. The tested devices based on slide-film damping effect are fabricated, and the tested quality factor is 514, which shows that grid strip capacitance design can partly improve the resolution and also prove the feasibility of the designed silicon-glass anodically bonding process.

Study of a Novel Micromachined Capacitive Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

A Novel Capacitive Biaxial Microaccelerometer Based on the Slide-Film Damping Effect

An Electrostatically-driven Capacitively-sensed Frame Microgyroscope Fabricated with an Improved Process Flow

A silicon capacitive acceleration sensor made in micromachining technology

A Novel Capacitive Micro-Accelerometer with Grid Strip Capacitances and Sensing Gap Alterable Capacitances

A Novel Tunable Lateral Sensing Capacitive Silicon Micromachined Accelerometer with High Sensitivity

Study Of A Novel Mems Accelerometer With Low Noise Reduced By Actuators

Design and Virtual Fabrication Process of a New Kind of Capacitive Accelerometer

Design and Fabrication Research on a Capacitive Accelerometer

Z-Axis Capacitive Accelerometer With Novel Beams Using Sog Structure

Fabrication and Test of a Capacitive Biaxial Microaccelerometer

Micromachined Tri-Axis Capacitive Accelerometer Based on the Single Mass

Design Of Readout Circuits Used For Micro-Machined Capacitive Accelerometer

Design, Fabrication and Test of a Low Range Capacitive Accelerometer With Anti-Overload Characteristics

A novel Z-axis capacitive accelerometer using-SOG structure

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

Design and experiment of high-overload capacitive micro-machined accelerometers

Design of a Micro Capacitive Acceleration Sensor Based on MEMS

Modeling and Analysis of a SiC Microstructure-Based Capacitive Micro-Accelerometer

A Capacitive Micro-Accelerometer Based on LTCC Laminates