Abstract:By using the capacitive measurement principle, high-performance micromechanical accelerometers provide low noise and power consumption, cost efficiency, and reliability. Capacitive sensors based on changes in the gap between the electrodes, as a rule, require closed-loop control, which increases the level of complexity of the measurement circuit and increases power consumption. Capacitive sensitive elements with a change in the electrode overlap area have a good linearity of the capacitance versus displacement and a large measurement range, but they are more difficult to manufacture. This paper presents and investigates a model of a sensitive element of a sandwich design of a capacitive micromechanical accelerometer, the functioning of which is based on the use of a change in the relative dielectric constant of the dielectric of capacitors due to the introduction of a movable inertial mass between the electrodes of the capacitors, moving under the action of acceleration. As a result, there is a change in capacitance in the output measuring circuit. It is shown that the considered model is sensitive to acceleration and resistant to temperature changes, with low residual mechanical stress in the sensitive element. The modeling and calculations are performed using the Ansys and SolidWorks software. It is found that the movement of the moving mass along the axis of sensitivity X is more than five times the movement of the moving mass along the nonworking axes, and the change in the capacitance between the electrodes along the axis X is almost 2500 times more than the changes in capacitance between electrodes along the nonworking axes Z and Y . Calculations have shown that for all values of the acting acceleration (up to 30 g), the mechanical stress in the sensitive element is much less than the ultimate strength of silicon, equal to 440 MPa. It is found that variation of the temperature from –40 to 85°C leads to minor changes in capacitance along the working axis (0.0025–0.003 pF). This indicates the temperature stability of the investigated micromechanical accelerometer sensing element. The results of the analysis show that the developed and investigated model of the sensitive element of the sandwich design ensures the sensitivity of the micromechanical accelerometer and the stability of its parameters.

A Capacitive Micro-Accelerometer Based on LTCC Laminates

Design, Fabrication, And Performance Characterization Of Ltcc-Based Capacitive Accelerometers

Folding Differential Capacitive Accelerometer Made of LTCC

A novel LTCC capacitive accelerometer embedded in LTCC packaging substrate.

Study of a Novel Micromachined Capacitive Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

A Thick Film Accelerometer Based on LTCC-technology

A New RF Capacitive Accelerometer Embedded in LTCC Packaging Substrate

Design of Force-Balance Capacitive Accelerometer

A Low-Power Digital Processing Circuit for Capacitive Accelerometer

A Novel Tunable Lateral Sensing Capacitive Silicon Micromachined Accelerometer with High Sensitivity

A Capacitive Pressure Sensor Based on LTCC/PDMS Bonding Technology

Design, Fabrication and Test of a Low Range Capacitive Accelerometer With Anti-Overload Characteristics

Design and Fabrication Research on a Capacitive Accelerometer

Design and Virtual Fabrication Process of a New Kind of Capacitive Accelerometer

A Wafer Level Vacuum Encapsulated Capacitive Accelerometer Fabricated in an Unmodified Commercial MEMS Process

A Low-Noise Closed-Loop Interface For High-G Capacitive Micro-Accelerometer

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

Modeling the Sensitive Element of the Sandwich Construction of a Capacitive Micromechanical Accelerometer, Taking into Account the Change in the Dielectric Constant

Design and Fabrication of MEMS Acceleration Sensor for Device-Level Vacuum Packaging

A SOI Sandwich Differential Capacitance Accelerometer with Low-Stress Package