Abstract:A novel three-dimensional (3D) hermetic packaging technique suitable for capacitive microelectromechanical systems (MEMS) sensors is studied. The composite substrate with through silicon via (TSV) is used as the encapsulation cap fabricated by a glass-in-silicon (GIS) reflow process. In particular, the low-resistivity silicon pillars embedded in the glass cap are designed to serve as the electrical feedthrough and the fixed capacitance plate at the same time to simplify the fabrication process and improve the reliability. The fabrication process and the properties of the encapsulation cap were studied systematically. The resistance of the silicon vertical feedthrough was measured to be as low as 263.5 mΩ, indicating a good electrical interconnection property. Furthermore, the surface root-mean-square (RMS) roughnesses of glass and silicon were measured to be 1.12 nm and 0.814 nm, respectively, which were small enough for the final wafer bonding process. Anodic bonding between the encapsulation cap and the silicon wafer with sensing structures was conducted in a vacuum to complete the hermetic encapsulation. The proposed packaging scheme was successfully applied to a capacitive gyroscope. The quality factor of the packaged gyroscope achieved above 220,000, which was at least one order of magnitude larger than that of the unpackaged. The validity of the proposed packaging scheme could be verified. Furthermore, the packaging failure was less than 1%, which demonstrated the feasibility and reliability of the technique for high-performance MEMS vacuum packaging.

Design and Fabrication of MEMS Acceleration Sensor for Device-Level Vacuum Packaging

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

A Wafer Level Vacuum Encapsulated Capacitive Accelerometer Fabricated in an Unmodified Commercial MEMS Process

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Study of a Novel Micromachined Capacitive Accelerometer

Wafer-Level Self-Packaging Design and Fabrication of MEMS Capacitive Pressure Sensors

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

Design and Fabrication of a Mems Capacitive Accelerometer Based on Double-Device-layers SOI Wafer.

A SOI Sandwich Differential Capacitance Accelerometer with Low-Stress Package

Fabrication and wafer-level vacuum packaging of MEMS resonant pressure sensor

A MEMS Sandwich Differential Capacitive Silicon-on-insulator Accelerometer

Research on a 3D Encapsulation Technique for Capacitive MEMS Sensors Based on Through Silicon Via

Design and Fabrication Research on a Capacitive Accelerometer

New Low-Cost MEMS Capacitive Pressure Sensor Concept

Fabrication and Characterization of a MEMS Thermal Convective Accelerometer on Silicon-in-Glass Substrate

Low stress packaging of a micromachined accelerometer

Fabrication of a MEMS Capacitive Accelerometer with Symmetrical Double-Sided Serpentine Beam-Mass Structure

A Capacitive Micro-Accelerometer Based on LTCC Laminates

Chip Level Packaging for Mems Using Silicon Cap

An Optical Interferometry Based MEMS Accelerometer Applicable to Seismic-Grade Measurement

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors