Abstract:In this research, a high-efficiency design method of the capacitive MEMS accelerometer is proposed. As the MEMS accelerometer has high precision and a compact structure, much research has been carried out, which mainly focused on the structural design and materials selection. To overcome the inconvenience and inaccuracy of the traditional design method, an orthogonal design and the particle swarm optimization (PSO) algorithm are introduced to improve the design efficiency. The whole process includes a finite element method (FEM) simulation, high-efficiency design, and verification. Through the theoretical analysis, the working mechanism of capacitive MEMS accelerometer is clear. Based on the comparison among the sweep calculation results of these parameters in the FEM software, four representative structural parameters are selected for further study, and they are le, nf, lf and wPM, respectively. le and lf are the length of the sensing electrode and fixed electrode on the right. nf is the number of electrode pairs, and wPM is the width of the mass block. Then, in order to reduce computation, an orthogonal design is adopted and finally, 81 experimental groups are produced. Sensitivity SV and mass Ma are defined as evaluation parameters, and structural parameters of experimental groups are imported into the FEM software to obtain the corresponding calculation results. These simulation data are imported into neural networks with the PSO algorithm. For a comprehensively accurate examination, three cases are used to verify our design method, and every case endows the performance parameters with different weights and expected values. The corresponding structural parameters of each case are given out after 24 iterations. Finally, the maximum calculation errors of SV and Ma are 1.2941% and 0.1335%, respectively, proving the feasibility of the high-efficiency design method.

Design and Fabrication Research on a Capacitive Accelerometer

Design and Virtual Fabrication Process of a New Kind of Capacitive Accelerometer

Study of a Novel Micromachined Capacitive Accelerometer

Design of Force-Balance Capacitive Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

A Stiffness-Tunable MEMS Accelerometer

Design and Fabrication of a Mems Capacitive Accelerometer Based on Double-Device-layers SOI Wafer.

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

Laterally Capacity Sensed Accelerometer Fabricated with the Anodic Bonding and the High Aspect Ratio Etching

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors

Design and Fabrication of A Torsional Z-Axis Capacitive Accelerometer with Novel Comb Capacitor

A MEMS Sandwich Differential Capacitive Silicon-on-insulator Accelerometer

A Capacitive Micro-Accelerometer Based on LTCC Laminates

A Highly Symmetrical Capacitive Accelerometer by Silicon Four-Layer Bonding

A Fully Symmetrical Capacitive Accelerometer with Precisely Controllable Capacitor Gap

Design, Fabrication and Test of a Low Range Capacitive Accelerometer With Anti-Overload Characteristics

A Wafer Level Vacuum Encapsulated Capacitive Accelerometer Fabricated in an Unmodified Commercial MEMS Process

The Design and Fabrication of A Miniaturized Differential-Capacitive Triaxial Accelerometer

Post-Cmos Selective Electroplating Technique for the Improvement of Cmos-Mems Accelerometers

A Rapid Design and Fabrication Method for a Capacitive Accelerometer Based on Machine Learning and 3D Printing Techniques