Abstract:RF-MEMS is one of the most potential applications for MEMS products. Eutectic solder wafer bonding is one of the attractive methods for RF-MEMS wafer level packaging. A process of gold-tin hermetical wafer bonding was developed in SAIT, Korean. Different UBM systems and thin films of gold-tin were deposited on cap wafer, RF-MEMS device wafer and substrate wafer (if needed). The bonding was performed in N2 ambience with pressure. The cross section of bonding layer had been studied using SEM/EDAX. The thickness of bonding layer is uniform, ranging from 5mum to 7mum. Pretreatment is important to obtain good adhesion and successful microstructure. Voids could be detected without ashing. Optimal process, such as plasma cleaning, would eliminate these voids. There existed different regions in the bonding layer due to inter-diffusion between Au-Sn and other elements. Different intermetallic formed at the bonding layer. The compositions of the intermetallic was identified by EDAX and analyzed according to the Au-Sn phase diagram. The microstructures of the bonding layer are similar for different bonding temperatures in experiments, which indicates lower bonding temperature can get the same hermetical sealing. Typically, there are Au rich layer, AuSn IMC layer and Sn/Au-Ni-Ti layer in the bonding layer between cap wafer and substrate wafer, while there are Au layer, Au-Sn-Ni compound layer in the bonding layer between device wafer and substrate wafer. From the EDAX analysis, different intermetallic compound (IMC) can be identified as AuSn2, AuSn and other composition. Hermetical and shear strength test were performed for as-bonded dice. The test results indicated there is little difference among different bonding process. Fracture surfaces after shear test were investigated as well. The fracture was inside Au-Sn IMC. It indicates the UBM selected is suitable for application. Reliability test was also performed

AnodicBonding StudyonVacuumMicroSealing Cavity

Hermetic Packaging of Mems with Thick Electrodes by Silicon-Glass Anodic Bonding.

MEMS vacuum packaging technology and applications

Investigation of Au/Si Eutectic Wafer Bonding for MEMS Accelerometers

Microstructure of AuSn Wafer Bonding for RF-MEMS Packaging

Implementation of Various Vacuum Conditions in Sealed Chambers for Wafer-Level Bonding by Using Embedded Cavity

Wafer Lever Packaging for Gyroscope by Au/Si Eutectic Bonding

Microstructural Characterization and Mechanical Performance of Wafer-Level SLID Bonded Au-Sn and Cu-Sn Seal Rings for MEMS Encapsulation

A novel method of anodic bonding

Micro-fabrication and hermeticity measurement of alkali-atom vapor cells based on anodic bonding

Evaluation method for MEMS silicon-glass anodic bonding process

Technique and Structure for Testing Bonding Intension in Micron Scale

A New Test Structure To Measure Bonding Strength In Micro-Bonding Area

Study on the mechanism of glass-SiC-glass anodic bonding process

Bonding Strength at Micro and Nano Levels

Au-Si Eutectic Bonding Technology for MEMS Device

Mechanical and electrical cold bonding based on metallic nanowire surface fasteners.

A low temperature, non-aggressive wafer level hermetic package with UV cured SU8 bond

Mechanism and Process of Cu-Sn Bonding for Wafer Level MEMS Packaging

Fabrication of Hermetic Cell Using MEMS Technology