Abstract:Au/Si eutectic bonding is considered to BE a promising technology for creating 3D structures and hermetic packaging in micro-electro-mechanical system (MEMS) devices. However, it suffers from the problems of a non-uniform bonding interface and complex processes for the interconnection of metal wires. This paper presents a novel Au/Si eutectic wafer bonding structure and an implementation method for MEMS accelerometer packaging. The related processing parameters influencing the Au/Si eutectic bonding quality were widely investigated. It was found that a high temperature of 400 °C with a low heating/cooling rate of 5 °C/min is crucial for successful Au/Si eutectic bonding. High contact force is beneficial for bonding uniformity, but the bonding strength and bonding yield decrease when the contact force increases from 3000 to 5000 N due to the metal squeezing out of the interface. The application of TiW as an adhesion layer on a glass substrate, compared with a commonly used Cr or Ti layer, significantly improves the bonding quality. The bonding strength is higher than 50 MPa, and the bonding yield is above 90% for the presented Au/Si eutectic bonding. Furthermore, the wafer-level vacuum packaging of the MEMS accelerometer was achieved based on Au/Si eutectic bonding and anodic bonding with one process. Testing results show a nonlinearity of 0.91% and a sensitivity of 1.06 V/g for the MEMS accelerometer. This Au/Si eutectic bonding process can be applied to the development of reliable, low-temperature, low-cost fabrication and hermetic packaging for MEMS devices.

A low temperature, non-aggressive wafer level hermetic package with UV cured SU8 bond

A New Route for Fabricating Polymer Optical Microcavities.

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

Low-temperature wafer-level bonding with cu-Sn-in solid liquid Interdiffusion for microsystem packaging

Chip Level Packaging for Mems Using Silicon Cap

Wafer Level Vacuum Packaging of MEMS-Based Uncooled Infrared Sensors

Bonding of Glass-Based Microfluidic Chips at Low- or Room-Temperature in Routine Laboratory

MEMS vacuum packaging technology and applications

Wafer Lever Packaging for Gyroscope by Au/Si Eutectic Bonding

Low temperature multi-layer wafer level package for chip scale atomic clock (CSAC)

A strategy of wafer-level-plastic-packaging for MEMS based on adhesive bonding

Fabrication of Hermetic Cell Using MEMS Technology

Fabrication and Characterization of Low Stress Si Interposer with Air-Gapped Si Interconnection for Hermetical System-in-Package

High Vacuum Packaging of MEMS Devices Containing Heterogeneous Discrete Components

A Generic Surface Micromachining Module for Mems Hermetic Packaging at Temperatures Below 200 degrees C

Hermetic Packaging of Mems with Thick Electrodes by Silicon-Glass Anodic Bonding.

Low-Temperature Bonding of Poly-(Methyl Methacrylate) Microfluidic Devices under an Ultrasonic Field

Fabrication of 1-d nanochannels on PMMA substrate by photoresist-free uv lithography and UV-assisted bonding under low temperature

Properties of room temperature bonded and UV cured temporary bonding adhesive for ultra-thin wafer's handling

Investigation of Au/Si Eutectic Wafer Bonding for MEMS Accelerometers