Abstract:We demonstrate the fabrication of $\sim$1.08 $\mu$m deep microfluidic cavities with characteristic size as large as 7 mm $\times$ 11 mm or 11 mm diameter, using a silicon$-$glass anodic bonding technique that does not require posts to act as separators to define cavity height. Since the phase diagram of $^3$He is significantly altered under confinement, posts might act as pinning centers for phase boundaries. The previous generation of cavities relied on full wafer-bonding which is more prone to failure and requires dicing post-bonding, whereas the these cavities are made by bonding a pre-cut piece of Hoya SD-2 glass to a patterned piece of silicon in which the cavity is defined by etching. Anodic bonding was carried out at 425 $^{\circ}$C with 200 V, and we observe that pressurizing the cavity to failure ($>$ 30 bar pressure) results in glass breaking, rather than the glass-silicon bond separation. In this article, we discuss the detailed fabrication of the cavity, its edges, and details of the junction between the coin silver fill line and the silicon base of the cavity that enables a low internal-friction joint. This feature is important for mass coupling torsional oscillator experimental assays of the superfluid inertial contribution where a high quality factor ($Q$) improves frequency resolution. The surface preparation that yields well-characterized smooth surfaces to eliminate pinning sites, the use of transparent glass as a cover permitting optical access, low temperature capability and attachment of pressure-capable ports for fluid access may be features that are important in other applications.

Fabrication of Hermetic Cell Using MEMS Technology

Micro-fabrication and hermeticity measurement of alkali-atom vapor cells based on anodic bonding

Hermetic Packaging of Mems with Thick Electrodes by Silicon-Glass Anodic Bonding.

Microfabrication of MEMS Alkali Metal Vapor Cells for Chip-Scale Atomic Devices

MEMS Vacuum Packaging Technology and Applications

Chip Level Packaging for Mems Using Silicon Cap

Wafer-Level Filling of MEMS Vapor Cells Based on Chemical Reaction and Evaporation

Novel Method of Fabricating Fabry-Perot Cavity Employing MEMS Wet-Etching Process

A low temperature, non-aggressive wafer level hermetic package with UV cured SU8 bond

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

Modulate the Chamber Pressure of the Hermetic Sealed Mems Device by Varying the Cavity Depth of Cap Si

Design and Implementation of Monolithically Integrated Sealed and Unsealed Chambers by Using the Wafer Level Packaging

Wafer-level vapor cells filled with laser-actuated hermetic seals for integrated atomic devices

Fabrication of SiC MEMS Pressure Sensor Based on Novel Vacuum-Sealed Method

Galvanic Etching for Sensor Fabrication

Fabrication of micro fluidic cavities using Si-to-glass anodic bonding

Laser-actuated hermetic seals for integrated atomic devices

Fabrication of SiC MEMS Pressure Sensor by Anodic Bonding

A Generic Surface Micromachining Module for Mems Hermetic Packaging at Temperatures Below 200 degrees C

Fabrication and Analysis of a Fabry-Perot Cavity with a Micromechanical Wet-Etching Process.