Abstract:Effective continuous glucose monitoring solutions require consistent sensor performance over the lifetime of the device, a manageable variance between devices, and the capability of high volume, low cost production. Here we present a novel and microfabrication-compatible method of depositing and stabilizing enzyme layers on top of planar electrodes that can aid in the mass production of sensors while also improving their consistency. This work is focused on the fragile biorecognition layer as that has been a critical difficulty in the development of microfabricated sensors. We test this approach with glucose oxidase (GOx) and evaluate the sensor performance with amperometric measurements of in vitro glucose concentrations. Spincoating was used to deposit a uniform enzyme layer across a wafer, which was subsequently immobilized via glutaraldehyde vapor crosslinking and patterned via liftoff. This yielded an approximately 300 nm thick sensing layer which was applied to arrays of microfabricated platinum electrodes built on blank wafers. Taking advantage of their planar array format, measurements were then performed in high-throughput parallel instrumentation. Due to their thin structure, the coated electrodes exhibited subsecond stabilization times after the bias potential was applied. The deposited enzyme layers were measured to provide a sensitivity of 2.3 ± 0.2 μA mM-1 mm-2 with suitable saturation behavior and minimal performance shift observed over extended use. The same methodology was then demonstrated directly on top of wireless CMOS potentiostats to build a monolithic sensor with similar measured performance. This work demonstrates the effectiveness of the combination of spincoating and vapor stabilization processes for wafer scale enzymatic sensor functionalization and the potential for scalable fabrication of monolithic sensor-on-CMOS devices.

Galvanic Etching for Sensor Fabrication

Sensitivity Enhancement of Soft Capacitive Pressure Sensors Using a Solvent Evaporation-Based Porosity Control Technique.

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

Fabrication and characterization of SiO2 microcantilever for microsensor application

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Galvanic Cell Formation: A Review of Approaches to Silicon Etching for Sensor Fabrication

Fabrication of Hermetic Cell Using MEMS Technology

Fabrication of High-Resolution Flexible Circuits and Sensors Based on Liquid Metal Inks by Spraying and Wiping Processing.

A hybrid polymer/ceramic/semiconductor fabrication platform for high-sensitivity fluid-compatible MEMS devices with sealed integrated electronics

Fabrication of a Flexible Amperometric Glucose Sensor Using Additive Processes.

Fabrication of SiC MEMS Pressure Sensor by Anodic Bonding

Patterned thin film enzyme electrodes via spincoating and glutaraldehyde vapor crosslinking: towards scalable fabrication of integrated sensor-on-CMOS devices

Galvanic etch stop for Si in KOH

Low Cost and High‐Aspect Ratio Micro/Nano Device Fabrication by Using Innovative Metal‐Assisted Chemical Etching Method

Fabrication and Performance of a Ta2O5 Thin Film pH Sensor Manufactured Using MEMS Processes

Simple and Robust Microfabrication of Polymeric Piezoelectric Resonating MEMS Mass Sensors

A Composite Nano-ink of Liquid Metal Nanoparticles and Carbon Nanotubes for the Fabrication of Flexible Pressure Sensors

Optimization of Thin Metal Layer Etch Process for MEMS/Sensor Application*

Fabrication of a MEMS Temperature Sensor on the Capillary Surface for Hyperthermia Intervention Monitoring

Microfluidics for High Pressure: Integration on GaAs Acoustic Biosensors with a Leakage-Free PDMS Based on Bonding Technology

Advancing pressure sensors performance through a flexible MXene embedded interlocking structure in a microlens array