Abstract:In this paper, a high-resistivity silicon (HR-Si) interposer integrated with through-silicon via (TSV) electrically grounded coplanar waveguide (CPW) line is presented for 2.5-D/3-D heterogeneous integration of radio frequency (RF) microelectronics devices. In addition, design of TSV interconnection composed of two coaxial ladder-hollow-annular Cu (copper) TSVs of different diameters is utilized to maintain a sufficient freedom for strict standard cleaning to avoid Si resistivity degradation. The formation of the coaxial ladder TSV structure is more beneficial to the subsequent plating process because it reduces the aspect ratio of TSV vias. Hollow-annular Cu TSV is manufactured in order to reduce the problem of mismatch in coefficient of thermal expansion among TSV's constituent materials. A layer of Au (aurum) film is utilized to passivate the exposed Cu surface of Si interposer. Au is widely used in III-V groups' devices because of the good compatibility with photonic integrated circuits, conductivity, and corrosion resistance. HR-Si interposer with TSV grounded CPW line and test structure is fabricated and characterized. With the monitoring test results, it can be found that it changes little in the resistivity of Si substrate, though the whole process, which is a basic requirement for RF performance. RF property test results show that the insertion loss is about -0.20 dB/mm at 10 GHz for the presented TSV grounded CPW line and -0.02 dB per TSV. These test results are better than the traditional design. To verify its applicability to 2.5-D/3-D heterogeneous integration, RF microelectronics die is assembled on TSV interposer and tested, and the test results prove that it works properly.

Electrical characteristics of a novel interposer technique using ultra-low-resistivity silicon-pillars with polymer insulation as TSVs

Fabrication and characterization of a low-cost interposer with an intact insulation layer and ultra-low TSV leakage current

Double-Shielded Interposer with Highly Doped Layers for High-Speed Signal Propagation

Two 10Gb/s/pin Low-Power Interconnect Methods for 3D ICs

Transmission Characteristics Of A Coaxial Through-Silicon Via (C-Tsv) Interconnect

Fabrication and RF Property Evaluation of High-Resistivity Si Interposer for 2.5-D/3-D Heterogeneous Integration of RF Devices

A Shielding Structure for Crosstalk Reduction in Silicon Interposer

Implementation of Air-Gap Through-Silicon-Vias (TSVs) Using Sacrificial Technology

Modeling and Measurement of A Novel Shielding Design in Silicon Interposer

Development of Ultra-Low Capacitance Through-Silicon-vias (tsvs) with Air-Gap Liner

Interposer Fabrication with Annular Copper Tsv and Multi-Layered Redistribution Layer

A RF Redundant TSV Interconnection for High Resistance Si Interposer

Fabrication and performances of a novel copper-ordered-reinforced polymer composite interposer

Modeling of the RF Coaxial TSV Configuration Inside the Silicon Interposer with Embedded Cooling Cavity

Design and Simulation of A Non-Silicon Composite Interposer with Reinforced Structure

Fabrication and Characterization of a Low Parasitic Capacitance and Low-Stress Si Interposer for 2.5-D Integration

A 2.5D Integrated L Band Receiver Based on High Resistivity Si Interposer

Design and fabrication of a TSV interposer for SRAM integration

A Novel Manufacturing Scheme for Tsvs with Porous Polymer Insulation Liners

Fabrication and Characterization of Low Stress Si Interposer with Air-Gapped Si Interconnection for Hermetical System-in-Package

Low Capacitance Through-Silicon-Vias with Uniform Benzocyclobutene Insulation Layers