Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Analysis of electrostatic discharge suppressors with ultra-low capacitance used for IC protection

Analysis of an ESD suppressor used for IC protection

Evaluation of RF electrostatic discharge (ESD) protection in 0.18-μm CMOS technology

Electro-Thermo-Mechanical Investigation On Multi-Level Interconnects In The Presence Of An Esd Pulse

An Investigation on Capacitance-Trigger ESD Protection Devices for High Voltage Integrated Circuits

A capacitance coupling complementation SCR for on-chip electrostatic discharge protection

Analyse of Protection Devices' Speed Performance against ESD under CDM Using TCAD

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

FOD Based ESD Protection Devices in Deep Sub-micron Technology

A Novel Capacitance-Coupling-Triggered SCR for Low-Voltage ESD Protection Applications

Design Analysis of a Novel Low Triggering Voltage Dual Direction SCR ESD Device in 0. 18μm Mixed Mode RFCMOS Technology

Low-Capacitance SCR Structure for RF I/O Application

Trigger voltage walk-in effect of ESD protection device in HVCMOS

Very Small Snapback Silicon-Controlled Rectifier for Electrostatic Discharge Protection in 28 Nm Processing.

Research on Electrostatic Discharge Characteristics of Tunnel Field Effect Transistors

Novel Capacitance Coupling Complementary Dual-Direction SCR for High-Voltage ESD

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

Investigation of Boundary-Mos-triggered SCR Structures for On-Chip ESD Protection

ESD Circuits Design for High-Speed Analog CMOS Integrated Circuits

A Novel and Powerful TCAD Methodology to Evaluate Performance of ESD Protection Devices