Abstract:Silica nanoparticles are widely utilized abrasives in chemical mechanical polishing (CMP), and the modification of abrasives and the incorporation of chemical additives represent primary strategies for enhancing CMP performance. In this study, we achieved a modification of the electrical properties of the colloidal silica surface by forming a coating film through the "grafting" of 3-aminopropyltriethoxysilane (APTES) onto the colloidal silica surface. This modification resulted in an augmented mechanical interaction between the abrasive and the wafer during the CMP process, leading to an enhanced material removal rate (MRR) of SiO 2 . However, the post-CMP surface exhibited a relatively higher occurrence of surface defects. Subsequently, cetyltrimethylammonium bromide (CTAB) was added as an auxiliary additive, which promoted the formation of a "special electrostatic self-assembly structure" on the surface of the abrasive, further elevating the SiO 2 MRR. Moreover, CTAB demonstrated the capability to adsorb onto the wafer surface, creating a protective effect that resulted in reduced surface roughness and a decrease in surface defects following CMP. Furthermore, comprehensive characterization of the modified abrasive was conducted using techniques such as transmission electron microscopy (TEM) and scanning electron microscopy (SEM). The mechanisms underlying the improvement in CMP performance were systematically analyzed through experimental phenomena and X-ray photoelectron spectroscopy (XPS), and revealing that the introduction of CTAB indirectly facilitated the adsorption of APTES onto the surface of the colloidal silica. Our study provides a method for the advanced process of SiO 2 CMP with stringent metal ion requirements.

Influence of abrasive and chemical composition on chemo-mechanical polishing of MgO single crystal substrate

Application of surface analysis in study on removal mechanism and abrasive selection during fused silica chemical mechanical polishing

Non-spherical abrasives with ordered mesoporous structures for chemical mechanical polishing

Optimization of polishing fluid composition for single crystal silicon carbide by ultrasonic assisted chemical-mechanical polishing

An Investigation on the Chemical Effect in Chemo-Mechanical Polishing

Surface modulation to enhance chemical mechanical polishing performance of sliced silicon carbide Si-face

Investigation of Chemical Mechanical Polishing Slurry of magnesium alloy

Study on electrochemical mechanical polishing process of silicon carbide crystal

Effect of cations on the improvement of material removal rate of silicon wafer in chemical mechanical polishing

Achieving Ultralow Surface Roughness and High Material Removal Rate in Fused Silica Via a Novel Acid SiO2 Slurry and Its Chemical-Mechanical Polishing Mechanism

Chemical effect on the material removal rate in the CMP of silicon wafers

Influence of Process Parameters on Material Removal Rate of Hard Disk in Chemical Mechanical Polishing

Study on uniform size and spherical CeO 2 abrasives synthesized by two-step method and their chemical mechanical polishing performances

Tribochemical mechanisms of abrasives for SiC and sapphire substrates in nanoscale polishing

Study on Chemical Mechanical Polishing Performances of Sapphire Wafer (0001) Using Silica-Based Slurry

Investigation into Chemo-Mechanical Fixed Abrasive Polishing of Fused Silica with the Assistance of Ultrasonic Vibration

Study on Uniform Size and Spherical Ceo2 Abrasives Synthesized by Two-Step Method and Their Chemical Mechanical Polishing Performances

Chemical Mechanical Polishing of Aluminum Alloys using Alumina-Based Slurry

A special electrostatic self-assembly structure of colloidal silica: Improving Chemical Mechanical Polishing performance

Research on Chemical Mechanical Polishing Technology for Zirconium-Based Amorphous Alloys

Polishing Properties of Porous Silica Abrasive on Hard Disk Substrate CMP