Abstract:A dual-layer titania film consisting of a sol-gel anatase layer over an interconnected porous anatase one was fabricated and its photoelectrochemical behavior as well as photocatalytic ability were studied in detail. The porous layer was fabricated through direct oxidation of a metallic Ti substrate with an aqueous hydrogen peroxide at 80 degrees C for 1 h. The Ti substrate with the porous titania layer was then subjected to a sol-gel spin-coating to deposit the upper titania layer. The dual-layer titania film as a whole was phase pure anatase after a subsequent thermal treatment at 450 degrees C. The UV-vis diffuse reflectance spectra and ambient photoluminescence spectra indicated that the porous anatase possessed a band gap width narrower than that of the sol-gel derived anatase, which was attributed to the relatively larger amounts of surface oxygen deficiency. Under UV illumination, both the saturated photocurrent and the activity to assist photodegradation of rhodamine B in water were nearly double that of the simply summation of those exhibited by the two component layers alone for the dual-layer film. The photocatalytic activity of the dual-layer film was even 3.5 times that of the sol-gel derived anatase film with identical film weight. This work demonstrates that an appropriate configuration of two titania layers derived by distinct routes, even if the titania is of the same crystal structure such as anatase, is possible to improve significantly the photoelectrochemical response as well as the photocatalytic activity, providing that the band gap of each titania is aligned properly so that the charge separation efficiency can be enhanced significantly.

Anatase TiO2 Films with 2.2 Ev Band Gap Prepared by Micro-Arc Oxidation

Controllable hydrothermal synthesis, optical and photocatalytic properties of TiO 2 nanostructures

Study on the preparation of titania films for photocatalytic application by micro-arc oxidation

Microstructures and Properties of N-Doped TiO_2 Films Grown by Atmospheric Pressure Chemical Vapor Deposition

Microstructures and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Chemical Vapor Deposition

Investigation of structure and properties of N-doped TiO2 thin films grown by APCVD

Anatase Tio2 Films with Dominant {001} Facets Fabricated by Direct-Current Reactive Magnetron Sputtering at Room Temperature: Oxygen Defects and Enhanced Visible-Light Photocatalytic Behaviors

Oxidation Conditions of Ti and Photocatalysis of TiO2 Ceramic Films

Structure and Properties of Nitrogen-Doped Titanium Dioxide Thin Films Grown by Atmospheric Pressure Chemical Vapor Deposition

Microstructure and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Enhanced Chemical Vapor Deposition（DBD-CVD）

Preparation of Porous Anatase Titania Film

Improved Optical Response and Photocatalysis for N-doped Titanium Oxide (tio2) Films Prepared by Oxidation of TiN

Preparation and Properties of N -Doped TiO2 Films by APCVD

Photocatalysts of Cr Doped Tio2 Film Prepared by Micro Arc Oxidation

Miscrostructure and Photoelectrical Performance of Titanium Oxide Film Prepared by In-Situ Oxidation on TiNi Alloy Surface

Photoelectrochemical and Optical Properties of N-doped TiO2 Thin Films Prepared by Oxidation of Sputtered TiNx Films

Photocatalytic Active Titania Thin Films through Oxidation of Metallic TI in Aqueous H202 Solutions Containing Various Block Copolymers

Preparation and Structural Analysis of TiO2 Photocatalytic Film Modified by Triethylamine

Photocatalytic Active Titania Thin Films Through Oxidation of Metallic Ti in Aqueous H2O2 Solutions Containing Various Block Copolymers

A Dual-Layer Titania Film with Enhanced Photocatalytic Activity

Efficient electrochromic performance of anatase TiO2 thin films prepared by nebulized spray deposition method