Abstract:A dual-layer titania film consisting of a sol-gel anatase layer over an interconnected porous anatase one was fabricated and its photoelectrochemical behavior as well as photocatalytic ability were studied in detail. The porous layer was fabricated through direct oxidation of a metallic Ti substrate with an aqueous hydrogen peroxide at 80 degrees C for 1 h. The Ti substrate with the porous titania layer was then subjected to a sol-gel spin-coating to deposit the upper titania layer. The dual-layer titania film as a whole was phase pure anatase after a subsequent thermal treatment at 450 degrees C. The UV-vis diffuse reflectance spectra and ambient photoluminescence spectra indicated that the porous anatase possessed a band gap width narrower than that of the sol-gel derived anatase, which was attributed to the relatively larger amounts of surface oxygen deficiency. Under UV illumination, both the saturated photocurrent and the activity to assist photodegradation of rhodamine B in water were nearly double that of the simply summation of those exhibited by the two component layers alone for the dual-layer film. The photocatalytic activity of the dual-layer film was even 3.5 times that of the sol-gel derived anatase film with identical film weight. This work demonstrates that an appropriate configuration of two titania layers derived by distinct routes, even if the titania is of the same crystal structure such as anatase, is possible to improve significantly the photoelectrochemical response as well as the photocatalytic activity, providing that the band gap of each titania is aligned properly so that the charge separation efficiency can be enhanced significantly.

Photocatalytic Active Titania Thin Films Through Oxidation of Metallic Ti in Aqueous H2O2 Solutions Containing Various Block Copolymers

Photocatalytic Active Titania Thin Films through Oxidation of Metallic TI in Aqueous H202 Solutions Containing Various Block Copolymers

Controllable hydrothermal synthesis, optical and photocatalytic properties of TiO 2 nanostructures

Fabrication of titania thin film with composite nanostructure and its ability to photodegrade rhodamine B in water

Photocatalytic Active Titania Nanowire Arrays on Ti Substrates

A Dual-Layer Titania Film with Enhanced Photocatalytic Activity

Soft-chemical Synthesis of Mesoporous Nitrogen-Modified Titania with Superior Photocatalytic Performance under Visible Light Irradiation

Titania Nanoflowers with High Photocatalytic Activity

Low Temperature Synthesis of Few-Layer Titanate Nanobelts on Ti Mesh and the Hot-Water Induced Transformations to Highly Photocatalytic Active Titania Nanorods

Ordered Mesoporous Thin Films Of Rutile Tio2 Nanocrystals Mixed With Amorphous Ta2o5

Low‐Temperature Transformation of Titania Thin Films from Amorphous Nanowires to Crystallized Nanoflowers for Heterogeneous Photocatalysis

Sandwich-like titania thin films with one/three-dimensional nanostructures for photocatalytic applications

Nanocrystalline Titania Made From Interactions Of Ti With Hydrogen Peroxide Solutions Containing Tantalum Chloride

Low-Temperature Growth of a Nitrogen-Doped Titania Nanoflower Film and Its Ability to Assist Photodegradation of Rhodamine B in Water

Large-Scale Preparation Of Ordered Titania Nanorods With Enhanced Photocatalytic Activity

Azobenzene-Containing Block Copolymer Templates for Robust Au@TiO2 Nanoporous Network Films Toward Hot-Electron-Mediated Efficient Visible-Light Photocatalysis

Porous titania films prepared from interactions of titanium with hydrogen peroxide solution

Titania Polyhedra Via Sodium Fluorotitanate Intermediates

Photocatalytic degradation of selected dyes by titania thin films with various nanostructures

Titania Nanowires Growing from P25 Nuclei: Facile Synthesis and the Improved Photocatalytic Activity

Natural ageing of nanostructured titania photocatalyst films