Abstract:A dual-layer titania film consisting of a sol-gel anatase layer over an interconnected porous anatase one was fabricated and its photoelectrochemical behavior as well as photocatalytic ability were studied in detail. The porous layer was fabricated through direct oxidation of a metallic Ti substrate with an aqueous hydrogen peroxide at 80 degrees C for 1 h. The Ti substrate with the porous titania layer was then subjected to a sol-gel spin-coating to deposit the upper titania layer. The dual-layer titania film as a whole was phase pure anatase after a subsequent thermal treatment at 450 degrees C. The UV-vis diffuse reflectance spectra and ambient photoluminescence spectra indicated that the porous anatase possessed a band gap width narrower than that of the sol-gel derived anatase, which was attributed to the relatively larger amounts of surface oxygen deficiency. Under UV illumination, both the saturated photocurrent and the activity to assist photodegradation of rhodamine B in water were nearly double that of the simply summation of those exhibited by the two component layers alone for the dual-layer film. The photocatalytic activity of the dual-layer film was even 3.5 times that of the sol-gel derived anatase film with identical film weight. This work demonstrates that an appropriate configuration of two titania layers derived by distinct routes, even if the titania is of the same crystal structure such as anatase, is possible to improve significantly the photoelectrochemical response as well as the photocatalytic activity, providing that the band gap of each titania is aligned properly so that the charge separation efficiency can be enhanced significantly.

Natural ageing of nanostructured titania photocatalyst films

Enhanced Ability of Nanostructured Titania Film to Assist Photodegradation of Rhodamine B in Water Through Natural Aging

Fabrication of titania thin film with composite nanostructure and its ability to photodegrade rhodamine B in water

Photocatalytic degradation of selected dyes by titania thin films with various nanostructures

Low-Temperature Growth of a Nitrogen-Doped Titania Nanoflower Film and Its Ability to Assist Photodegradation of Rhodamine B in Water

Controllable hydrothermal synthesis, optical and photocatalytic properties of TiO 2 nanostructures

Photocatalytic Active Titania Thin Films through Oxidation of Metallic TI in Aqueous H202 Solutions Containing Various Block Copolymers

Photocatalytic Active Titania Thin Films Through Oxidation of Metallic Ti in Aqueous H2O2 Solutions Containing Various Block Copolymers

Low‐Temperature Transformation of Titania Thin Films from Amorphous Nanowires to Crystallized Nanoflowers for Heterogeneous Photocatalysis

Photodegradation of an Azo Dye Using Immobilized Nanoparticles of TiO2 Supported by Natural Porous Mineral.

Large-Scale Preparation Of Ordered Titania Nanorods With Enhanced Photocatalytic Activity

Photodegradation Of Rhodamine B In Water Assisted By Titania Nanorod Thin Films Subjected To Various Thermal Treatments

Improved Performance and Prolonged Lifetime of Titania-Based Materials: Sequential Use As Adsorbent and Photocatalyst

Titania Nanoflowers with High Photocatalytic Activity

Sandwich-like titania thin films with one/three-dimensional nanostructures for photocatalytic applications

A Dual-Layer Titania Film with Enhanced Photocatalytic Activity

Low Temperature Synthesis of Few-Layer Titanate Nanobelts on Ti Mesh and the Hot-Water Induced Transformations to Highly Photocatalytic Active Titania Nanorods

Photocatalytic activity of TiO 2 nanorods, nanowires and nanoflowers filled with TiO 2 nanoparticles

The Preparation of TiO_(2-x)N_x(0<x<1) Thin Films by Sol-Gel Method and Its Photocatalysis and Hydrophilic Properties

FINE STRUCTURE OF TITANIA SOL AND ITS PHOTOCATALYTIC ACTIVITY

Synthesis of Natural Porous Minerals Supported Tio2 Nanoparticles and Their Photocatalytic Performance Towards Rhodamine B Degradation