Abstract:Tungsten oxide (WO3-x) thin films were fabricated by reactive magnetron sputtering at glancing angle alpha=0 degrees or alpha=80 degrees, and then titanium oxide (TiO2) was deposited on it. X-ray diffraction (XRD), field emission scanning electron microscopy (FE-SEM) and X-ray photoelectron spectroscopy (XPS) were employed to characterize the crystal structure, surface/cross-section morphologies, and surface chemical composition of the WO3-x/TiO2 thin films. Electrochromic properties of the WO3-x/TiO2 thin films were measured by electrochemical workstation in three-electrode system with 1 mol/L LiClO4/PC solution and UV-Vis spectrophotometer. Results reveal that the WO3-x/TiO2 thin films present totally amorphous structure independent on glancing angles. As the glancing angle is kept at 80 degrees, the nano-columnar porous thin film is obtained. Substoichiometric tungsten oxide (WO3-x) and stoichiometric titanium oxide (TiO2) are confirmed by XPS spectra of W 4f and Ti 2p, respectively. Compared with the dense thin film, the nano-columnar porous film needs a lower driving potential and presents faster response. The charge capacity of the nano-columnar porous film is calculated to be 83.78 mC, which is over twice higher than 30.83 mC of the dense film. The intercalation and deintercalation ion diffusion rates are determined to be D-in=5.69x10(-10) cm(2).s(-1) and D-de=5.08x10(-10) cm(2).s(-1) at the applied potential +/- 1.2 V, respectively. The electrochromic cycle of the nano-columnar porous WO3-x/TiO2 thin film is more stable than that of pure WO3 thin film. The optical density variation (Delta OD) of the nano-columnar porous thin film is larger than that of the dense thin film due to the larger optical modulation amplitude in the whole visible wavelengths.

Efficient electrochromic performance of anatase TiO2 thin films prepared by nebulized spray deposition method

Electrochromism of titanium oxide thin films

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

A facile synthesis of porous amorphous/crystalline TiO2 hybrids for enhanced electrochromic performances

Building Architecture of TiO2 Nanocrystals Embedded in Amorphous WO3 Films with Improved Electrochromic Properties

Photocatalytic Active Titania Thin Films through Oxidation of Metallic TI in Aqueous H202 Solutions Containing Various Block Copolymers

Enhanced Electrochromic Properties of Donor–acceptor Polymers Via TiO2 Composite

Enhanced electrochromic properties of anatase TiO2 for flexible electrochromic device

Fabrication of electrochromic TiO2:Nb films by ultrasonic spray pyrolysis

A Study Of Titanium Oxide Film Electrodes Prepared By Direct Thermal Oxidation - Ii. Photoelectrochemical Performance

Cobalt Ion-Modified Titanium Oxide Nanorods: A Promising Approach for High-Performance Electrochromic Application

Lithium doping in spray-pyrolyzed NiO thin films: results on their microstructural, optical and electrochromic properties

(Invited) Pure Anatase Phase Titanium Dioxide Thin Films Prepared by Mist Chemical Vapor Deposition Applying for Photocatalysis

Improved electrochromic device based on mesoporous TiO2 and NiO films

Facile Synthesis of A Narrow-Gap Titanium Dioxide Anatase/Rutile Nanofiber Film on Titanium Foil with High Photocatalytic Activity under Sunlight

Electrochromic Properties of Nano-columnar Porous WO<sub>3-x</sub>/TiO<sub>2</sub> Thin Films

Preparation and Electrochromism of Amorphous Bi-doped TiO2 Film for Aqueous-Based Electrochromic Device

Synthesis of Nitrogen-Doped Carbon Embedded TiO2 Films for Electrochromic Energy Storage Application

Photoelectrochemical Properties of Anatase TiO2 Films Prepared by Improved Liquid Phase Deposition

Dip-Coating Process Engineering and Performance Optimization for Three-State Electrochromic Devices

Preparation and Electrochromic Performance of NiO/TiO2 Nanorod Composite Film