Abstract:Due to the advent of various foldable electric devices, it is becoming increasingly important to understand the bending properties of film materials. Bending of isotropic materials may be trivial if elastic deformation is small within a range of linear elasticity, which is often the case for bending. However, bending of polymer films, often used in recent foldable devices, may not be the case. Polymer films are frequently fabricated with stretching, which induces anisotropic orientation of molecular chains. In addition, there are many studies on bimodulus materials, which suggest the importance of the difference in tensile and compressive elastic moduli, i.e. , the importance of elastic asymmetry , considering that bending involves compression and extension. In this study, we extended the standard linear elastic theory to include elastic anisotropy and elastic asymmetry and developed a method for obtaining compressive moduli of films, which cannot be obtained by a simple compression test because thin films under compression buckle at small strains. Our method is based on a bending test combined with a uniaxial tension test, which allows the measurement of Poisson's ratio in addition to Young's modulus, which are both anisotropic and asymmetric. To test our theory and method, we further performed experiments on biaxially stretched poly(ethylene terephthalate) (PET) films. As a result, we found non-negligible anisotropy in Poisson's ratio and non-negligible asymmetry (bimodulus) in tensile and compressive moduli. We further justify our framework by demonstrating a clear data collapse to show agreement between experiment and theory, clarifying limitations. Our results suggest the importance of elastic anisotropy and elastic asymmetry in bending of industrial films and give fundamental knowledge on this subject, which would be useful for applications. Such applications include the control of the position of the neutral plane and precise measurements of elastic moduli and Poisson's ratio, which are crucial, e.g. , for the development of tough flexible electric devices and for the structural designs using compliant mechanisms.

Measurement of elastic modulus of films by three-point bend test

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Study on elastic modulus of ultra-thin copper films by in-situ SEM-SPM nanoindentation

SEM In Situ Study on Deformation Behavior of Cu and Cu/Ni Films under Three-Point Bending

In situ nanomechanical measurement of Cu nanowires

Measuring Thin Film Elastic Modulus Using A Micromachined Cantilever Bending Test by Nanoindenter

SEM In-Situ Investigation on Failure of Nanometallic Film/substrate Structures under Three-Point Bending Loading

Measurement Study for Elastic Modulus of Metal Wires

A study of the elastic moduli of corrosion products using nano-indentation techniques

Determining the Elastic Modulus of Thin Films Using a Buckling-Based Method: Computational Study

Study of Adhesion for Cu/Ru(Zn) on Dielectrics by an Improved Four-Point Bending Measurement

MEASUREMENT OF DEFORMATION OF PURE Ni FOILS BY SPECKLE PATTERN INTERFEROMETRY

SEM in-situ investigation on micro failure characterizations of multi Cu/Ni films under bending loading

In Situ Nanoindentation Mechanical Property of Films by Atomic Force Microscope

In situ study on bending modulus of Al2O3nanotubes prepared by atomic layer deposition

Measuring the elastic modulus and residual stress of freestanding thin films using nanoindentation techniques

Buckling Behavior Of Metal Film/Substrate Structure Under Pure Bending

Accurate measurement of thin film mechanical properties using nanoindentation

Bending of polymer films: a method for obtaining a compressive modulus of thin films

Measurement of Elastic Bi-modulus of Rock-type Materials: Insight from comparative and parallel tests

Micromechanical Characterization of AlCu Films for MEMS Using Instrumented Indentation Method