Abstract:Preparing high-quality AlN films at low temperatures is always highly demanded in plenty of application-fields, despite the high temperature is always necessary to enable the AlN crystallization. Therefore, improving the structural properties at low temperature is still challenging in the field. In the present work, the metal organic chemical vapor deposition (MOCVD) grown AlN nucleation layer is employed to improve the crystallinity and morphology of sputtered AlN on 6-inch Si (111) substrate at the temperature even as low as 100°C where it is not principally possible to achieve the crystallization of sputtered AlN. When compared with the as-sputtered AlN prepared even at 650°C, it is found that the full width at half maximum (FWHM) of AlN (002) X-ray rocking curves is intensively decreased to 0.96° from 1.61°, and such a reduction indicates that the screw dislocation density is decreased from 7.31×1010 down to 2.14×1010/cm2. In addition to the crystallinity, the morphology is also obviously improved that the root-mean-square (RMS) roughness is reduced from 4.99 nm down to 0.83 nm in a scanned area of 3×3 μm2 through introducing AlN nucleation. Therefore, such a combination highlights the contribution of AlN nucleation grown by MOCVD in improving the structural properties of low-temperature sputtered AlN layer which is compatible with the manufacturing of Si integrated circuits.

Low temperature cofired and multilayer substrates

A technique of burn-out for low temperature cofired a1n multilayer substrates

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Two-step Burnout Technique and Low-Temperature Cofiring of Multilayer Aluminum Nitride Substrates

Microstructure of low-temperature sintered AlN

Metallization development for AIN/W cofired substrate at low temperature

Tape-casting fabrication of low-temperature sintering-AlN substrate with high thermal conductivity

Effects of Li2o on the Low Temperature Sintering and Thermal Conductivity of Aln Ceramics

Al-Cr Coatings Prepared by Diffusion at Low Temperature and Its Phase Characterization

Ultra-Low-Temperature Cofired Ceramic Substrates with Low Residual Carbon for Next-Generation Microwave Applications

Fabrication of High Thermal Conductivity Aluminum Nitride Ceramics via Digital Light Processing 3D Printing

Effect of Substrate Temperature on Structural, Electrical and Optical Properties of Al-N Co-Doped Zno Thin Films

Low-temperature sintering of Al2O3 ceramics doped with 4CuO-TiO2-2Nb2O5 composite oxide sintering aid

AlN coatings with high thermal conductivity and excellent electrical properties for thermal management devices

Hot-pressing sintered AlN-BN ceramics with high thermal conductivity and low dielectric loss

Interfacial Defects in AlN/W Cofired Substrates

Improving the structural performance of low-temperature sputtered AlN on silicon substrate

Novel fabrication process of AlN ceramic matrix composites at low temperatures

Improvement of thermal management capability of AlN coatings via adjusting nitrogen pressure

Effect of Y2O3 on low temperature sintering and thermal conductivity of AlN ceramics

Low firing temperature ceramic material for high frequency multilayer chip inductors