Abstract:This paper deals with a systematic investigation on the synthesis of aluminium oxide starting from mono hydroxy aluminium oxide (boehmite, (AlOOH)) which in turn is synthesized from aluminium nitrate. Boehmite on heating forms γ, transitional alumina and α-alumina phases in the temperature range 400–600, 800–1050 and 1050–1100°C respectively. Calculation from XRD, using Scherer equation shows that γ-alumina has crystallite size in the range 5–10 nm, while δ and θ-alumina are in the range 10–20 nm and α-alumina is about ∼33 nm. The textural features of aqueous sol-gel boehmite samples calcined at various temperatures were analyzed by specific surface area measurements and adsorption isotherm features. Maximum specific surface area of 266 m2/g is observed for the precursor calcined at 400°C and a minimum of 5 m2/g at 1100°C. Total pore volume is maximum for the precursor calcined at 600°C (0.2653 cm3/g). Average pore size ranges from ∼3 nm (400°C) to ∼11 nm (1100°C). The adsorption isotherms also show a change from Type IV to Type II with increase in temperature showing difference in surface properties. The information from t-plots, pore size distribution and cumulative pore volume data also indicates differences in porosity features of boehmite on calcination. The adsorption isotherm and pore size distribution analysis show maximum microporosity at 400°C, while maximum mesoporosity is observed at 600°C. At higher temperatures, porosity decreases, even though small fraction of pores in the mesopore range is still retained. At 1100°C, there is structural transformation from transitional to α-alumina, with very low specific surface area ∼5 m2/g and pores in the size range of 11 nm. The various data presented in this study will be useful in the synthesis of alumina with tailor made properties.

Synthesis of Al2O3 nanopowders using inorganic salt and its physical chemistry

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Adsorption Isotherm and Pore Characteristics of Nano Alumina Derived from Sol-Gel Boehmite

Preparation of Pseudo-Boehmite and Gamma-Al2o3 by Polyaluminum Chloride Ii -Surfactant Influences

A new route to synthesis of γ-alumina nanorods

Synthesis and phase formation mechanism of alpha-Fe2O3 powders by hydrothermal reaction method

Preparation and Characterization of Nanocrystalline Gamma-Al2o3 by Sol-Gel Process

Green synthesis of nanometer gamma-Al2O3 powders by sol-gel method

OPTIMIZATION OF HEAT TREATMENT TECHNOLOGY OF NANO Al2O3 POWDERS

Preparation of Pseudo-Boehmite and Gamma-Al2o3 Granules by Polyaluminum Chloride I-Preparation Conditions

Facile synthesis of nano-crystalline alpha-alumina at low temperature via an absolute ethanol sol-gel strategy

Preparation of pseudo-boehmite and γ-Al2O3 granules by polyaluminum chloride i -preparation conditions

Preparation And Characterization Of Gamma-Al2o3 By Polyaluminum Chloride With High Al-13 Content

Synthesis of Al(OH)3Nanostructures from Al(OH)3Microagglomerates Via Dissolution-Precipitation Route

Synthesis and structural characterization of alumina nanoparticles

Features of Nanosize Boehmite Hydrothermal Synthesis

Preparation and characterisation of boehmite precursor and sinterable alumina powder from aqueous aluminium chloride-urea reaction

Synthesis of α-Al2O3 Nanopowders at Low Temperature from Aluminum Formate by Combustion Process

Influence of heat treatment conditions on the size and morphology of nano gamma-Al2O3 powders

Reactive Crystallization Kinetics Study of Boehmite in Ammonia Solution by Adding Ammonium Aluminum Sulfate

Synthesis and sintering behavior of a nanocrystalline α-alumina powder