Abstract:This paper deals with a systematic investigation on the synthesis of aluminium oxide starting from mono hydroxy aluminium oxide (boehmite, (AlOOH)) which in turn is synthesized from aluminium nitrate. Boehmite on heating forms γ, transitional alumina and α-alumina phases in the temperature range 400–600, 800–1050 and 1050–1100°C respectively. Calculation from XRD, using Scherer equation shows that γ-alumina has crystallite size in the range 5–10 nm, while δ and θ-alumina are in the range 10–20 nm and α-alumina is about ∼33 nm. The textural features of aqueous sol-gel boehmite samples calcined at various temperatures were analyzed by specific surface area measurements and adsorption isotherm features. Maximum specific surface area of 266 m2/g is observed for the precursor calcined at 400°C and a minimum of 5 m2/g at 1100°C. Total pore volume is maximum for the precursor calcined at 600°C (0.2653 cm3/g). Average pore size ranges from ∼3 nm (400°C) to ∼11 nm (1100°C). The adsorption isotherms also show a change from Type IV to Type II with increase in temperature showing difference in surface properties. The information from t-plots, pore size distribution and cumulative pore volume data also indicates differences in porosity features of boehmite on calcination. The adsorption isotherm and pore size distribution analysis show maximum microporosity at 400°C, while maximum mesoporosity is observed at 600°C. At higher temperatures, porosity decreases, even though small fraction of pores in the mesopore range is still retained. At 1100°C, there is structural transformation from transitional to α-alumina, with very low specific surface area ∼5 m2/g and pores in the size range of 11 nm. The various data presented in this study will be useful in the synthesis of alumina with tailor made properties.

Synthesis and structural characterization of alumina nanoparticles

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Adsorption Isotherm and Pore Characteristics of Nano Alumina Derived from Sol-Gel Boehmite

Optical and structural properties of spherical-shaped boehmite and γ-alumina nanoparticles by ultrasonic-assisted hydrothermal method: the effects of synthesis route, calcination, and precursor concentration

Structure and phase changes of alumina produced by flame hydrolysis

Tuning the structure of alumina

Synthesis and characterization of sol–gel alumina nanofibers

Synthesis and Characterization of Gibbsite Nanostructures

The structure and phase transformations in fumed transition alumina by X-ray diffraction and solid-state NMR

Synthesis of Aluminium Borate Nanowires by Sol–gel Method

Synthesis and sintering behavior of a nanocrystalline α-alumina powder

Synthesis of nano α-alumina powders using hydrothermal and precipitation routes: a comparative study

Microstructure, Morphology and Their Annealing Behaviors of Alumina Films Synthesized by Ion Beam Assisted Deposition

Microstructures of Nanosized Alumina Powders Synthesized by Sol-Gel Method

The Microstructure, Morphology, and Mechanical Properties of Sol-Gel-derived Amorphous Aluminum Oxide Films

Characteristics of Synthesized Alumina Nanoparticles in a High-Pressure Radio Frequency Thermal Plasma Reactor

Size-controlled synthesis of alumina nanoparticles from aluminum alkoxides

Nano Alumina: A Review of the Powder Synthesis Method

Chemical and Structural Characterization of Amorphous and Crystalline Alumina Obtained by Alternative Sol–Gel Preparation Routes

Synthesis and characterization of activated alumina with high thermal stability by a low-heat solid-phase precursor method

A new route to synthesis of γ-alumina nanorods