Abstract:The sol-gel process is a more chemical method (wet chemical method) for the synthesis of various nanostructures, especially metal oxide nanoparticles. In this method, the molecular precursor (usually metal alkoxide) is dissolved in water or alcohol and converted to gel by heating and stirring by hydrolysis/alcoholysis. Since the gel obtained from the hydrolysis/alcoholysis process is wet or damp, it should be dried using appropriate methods depending on the desired properties and application of the gel. For example, if it is an alcoholic solution, the drying process is done by burning alcohol. After the drying stage, the produced gels are powdered and then calcined. The sol-gel method is a cost-effective method and due to the low reaction temperature there is good control over the chemical composition of the products. The sol-gel method can be used in the process of making ceramics as a molding material and can be used as an intermediate between thin films of metal oxides in various applications. The materials obtained from the sol-gel method are used in various optical, electronic, energy, surface engineering, biosensors, and pharmaceutical and separation technologies (such as chromatography). The sol-gel method is a conventional and industrial method for the synthesis of nanoparticles with different chemical composition. The basis of the sol-gel method is the production of a homogeneous sol from the precursors and its conversion into a gel. The solvent in the gel is then removed from the gel structure and the remaining gel is dried. The properties of the dried gel depend significantly on the drying method. In other words, the “removing solvent method” is selected according to the application in which the gel will be used. Dried gels in various ways are used in industries such as surface coating, building insulation, and the production of special clothing. It is worth mentioning that, by grinding the gel by special mills, it is possible to achieve nanoparticles.

Green synthesis of nanometer gamma-Al2O3 powders by sol-gel method

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Preparation and Characterization of Nanocrystalline Gamma-Al2o3 by Sol-Gel Process

Influence of heat treatment conditions on the size and morphology of nano gamma-Al2O3 powders

Facile synthesis of nano-crystalline alpha-alumina at low temperature via an absolute ethanol sol-gel strategy

Synthesis of Gamma-Alumina Nanopowders Using Waste Metal Aluminum and Stability Surfactants

New sol-gel route using inorganic salt for synthesizing Al2O3 nanopowders

Progress in Research on Nanometer Al2o3 Fabricated by Sol-Gel Method

Synthesis of Al2O3 nanopowders using inorganic salt and its physical chemistry

OPTIMIZATION OF HEAT TREATMENT TECHNOLOGY OF NANO Al2O3 POWDERS

Preparation and Characterization of gamma-Al2O3 Nanocrystals by Hydrothermal Assisted Sol-gel Method

Preparation of nanosized CoAl2O4 powders by sol–gel and sol–gel-hydrothermal methods

Preparation of Large-Pore-Volume Gamma-Alumina Nanofibers with A Narrow Pore Size Distribution in A Membrane Dispersion Microreactor

Microstructure and Performance of Nanometer Γ-Al2o3p/al Composite Fabricated in Al-Co3O4 Components

Synthesis of γ-alumina via precipitation in ethanol

A Novel Method To Synthesize Amorphous Silica−Alumina Materials with Mesoporous Distribution without Using Templates and Pore-Regulating Agents

Synthesis and sintering behavior of a nanocrystalline α-alumina powder

Ultrasonic Synthesis of Silica−Alumina Nanomaterials with Controlled Mesopore Distribution Without Using Surfactants

Coprecipitation Synthesis of Large-Pore-Volume -Alumina Nanofibers by Two Serial Membrane Dispersion Microreactors with a Circulating Continuous Phase

Preparation of Fe_2O_3/Al Nanocomposite by Sol-gel Method

Nanomaterial by Sol-Gel Method: Synthesis and Application