Influence of sulfur partial pressure on the structural performance of Cu2ZnSnS4 solar cells
Xiaoming Li,Ruiting Hao,Kang Gu,Jie Guo,Jinghui Mo,Shuiliu Fang,Xinxing Liu,Yong Li,Guoshuai Wei,Bin Liu,Lu Wang,Shuaihui Sun,Huimin Liu,Xiaole Ma
DOI: https://doi.org/10.1016/j.mssp.2020.105552
IF: 4.1
2021-03-01
Materials Science in Semiconductor Processing
Abstract:CZTS precursors was deposit by sputtering, and then annealed in the range of 1000–5000 Pa sulfur partial pressure. The partial pressure of sulfur is controlled by changing the amounts of sublimed sulfur in a small, sealed quartz tube. As the sulfur partial pressure increased, the crystallinity of CZTS thin film was improved; surface voids and secondary phases were reduced; the thickness of MoS2 at low sulfur partial pressure ranging from 1000 Pã3000 Pa. After the sulfur partial pressure reaching 5000 Pa, the thickness of MoS2 increased significantly. The secondary phases, voids and MoS2 reduced the carrier collection in the 500–800 nm wavelength range, resulting in lower short-circuit current density and fill factor. Finally, the device based on the 3000 Pa sulfur partial pressure achieved the highest photoelectric conversion efficiency of 4.25% (V OC : 0.648 V, I SC : 15.25 mA/cm2, FF: 43.02%).
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied