Abstract:Patterned copper sulfide (Cu(x)S) microstructures on Si (1 1 1) wafers were successfully fabricated by a relatively simple solution growth method using copper sulfate, ethylenediaminetetraacetate and sodium thiosulfate aqueous solutions as precursors. The Cu(x)S particles were selectively deposited on a patterned self-assembled monolayer of 3-aminopropyltriethoxysilane regions created by photolithography. To obtain high quality Cu(x)S films, preparative conditions such as concentration, proportion, pH and temperature of the precursor solutions were optimized. Various techniques such as optical microscopy, atomic force microscopy (AFM), X-ray diffraction, optical absorption and scanning electrochemical microscopy (SECM) were employed to examine the topography and properties of the micro-patterned Cu(x)S films. Optical microscopy and AFM results indicated that the Cu(x)S micro-pattern possessed high selectivity and clear edge resolution. From combined X-ray diffraction analysis and optical band gap calculations we conclude that Cu(9)S(5) (digenite) was the main phase within the resultant Cu(x)S film. Both SECM image and cyclic voltammograms confirmed that the Cu(x)S film had good electrical conductivity. Moreover, from SECM approach curve analysis, the apparent electron-transfer rate constant (k) in the micro-pattern of Cu(x)S dominated surface was estimated as 0.04 cm/s. The SECM current map showed high edge acuity of the micro-patterned Cu(x)S.

FABRICATION AND CHARACTERIZATION OF CuxS THIN FILM BY ELECTRODEPOSITING

Research on CuInS2 Thin Films Prepared by One-step Electrodeposition

Fabrication and characterization of CuInS 2 films by chemical bath deposition in acid conditions

EFFECT OF THE COMPLEX IN ELECTRODEPOSITION ON CdS PHOTOVOLTAIC MATERIALS

Effect of Heat Treatment on the Property of Cuins2 Thin Film Prepared by Chemical Bath Deposition

EFFECT OF ANNEALING ON THE CuInS2 THIN FILMS PREPARED BY CHEMICAL BATH DEPOSITION

CdS THIN FILMS FABRICATED BY CHEMICAL BATH DEPOSITION

Synthesis, Growth and Characterization of Cu2CoSnS4 Thin Films via Thermal Evaporation Method

Scanning electrochemical microscopy studies of micropatterned copper sulfide (Cu(x)S) thin films fabricated by a wet chemistry method

Optimization of Fabrication Parameters of CuInSe2 Thin Films by DC-Magnetron Sputtering the Metal Precursor Followed by Selenization

Phase composition of the earth-abundant Cu2SnS3 thin films with different annealing temperature and its effects on the performance of the related solar cells

Structural Characterization of CuInS2 Thin Films from Cu–In Metal Inks

Effects of Preparation Conditions on the CuInS2 Films Prepared by One-Step Electrodeposition Method

CuInS 2 thin films obtained by solid-state sulfurization

Structural, optical and magnetic properties of Cu 2 NiSnS 4 thin films deposited by facile one-step electrodeposition

Effect of sulfurization time on the properties of copper zinc tin sulfide thin films grown by electrochemical deposition

Growth and properties of CuInS2 films by solid-state sulfurization

Electrochemical Synthesis and Characterization of Mesoporous Cu/Cu2O Films

Effect of triethanolamine complexing agent and thermal annealing on the physicochemical properties of CuS thin films

Synthesis of Cu2−xS electrocatalysts with different stoichiometric numbers by electrodeposition and heat posttreatment

Preparation and properties of compositionally tunable Cu3Sb(Sx,Se1-x)4 thin films