Abstract:Solid concentration and particle velocity distributions in the transition section of a ϕ 200mm turbulent fluidized bed (TFB) and a ϕ 200mm annulus turbulent fluidized bed (A-TFB) with a ϕ 50mm central standpipe were measured using a PV6D optical probe. It is concluded that in turbulent regime, the axial distribution of solid concentration in A-TFB was similar to that in TFB, but the former had a shorter transition section. The axial solid concentration distribution, probability density, and power spectral distributions revealed that the standpipe hindered the turbulence of gas–solid two-phase flow at a low superficial gas velocity. Consequently, the bottom flow of A-TFB approached the bubbling fluidization pattern. By contrast, the standpipe facilitated the turbulence at a high superficial gas velocity, thus making the bottom flow of A-TFB approach the fast fluidization pattern. Both the particle velocity and solid concentration distribution presented a unimodal distribution in A-TFB and TFB. However, the standpipe at a high gas velocity and in the transition or dilute phase section significantly affected the radial distribution of flow parameters, presenting a bimodal distribution with particle concentration higher near the internal and external walls and in downward flow. Conversely, particle concentration in the middle annulus area was lower, and particles flowed upward. This result indicated that the standpipe destroyed the core-annular structure of TFB in the transition and dilute phase sections at a high gas velocity and also improved the particle distribution of TFB. In conclusion, the standpipe improved the fluidization quality and flow homogeneity at high gas velocity and in the transition or dilute phase section, but caused opposite phenomena at low gas velocity and in the dense-phase section.

The Measure of Flow Characteristics in Shell Side and Improvement of the Single Inlet Hollow Fiber Module

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Residence time distribution in a new horizontal self-cleaning reactor with viscous media

Analysis on the structure of different hollow fiber membrane contactors

Effect of packing density of hollow fiber contactors on shell-side mass transfer in distillation

Effect of Random Packing on Shell-Side Flow and Mass Transfer in Hollow Fiber Module Described by Normal Distribution Function

Effect of Fiber Packing Density on Performance and Mass Transfer of Hollow Fiber Membrane Contactor

[Membrane Fouling Control in a Free-End Comb-Like Hollow Fiber Membrane Bioreactor].

Numerical Simulation of the Shell-Side Mass Transfer of Randomly Packed Hollow Fiber Modules with Constant Fiber Wall Concentration

Shell-side Mass Transfer Coefficient in Randomly Packed Hollow Fiber Bundles

Characteristics of shell-side mass transfer with hollow fibers random distribution in dialyzer

Shell side mass transfer in a transverse flow hollow fiber membrane contactor

Effect of coating based on various hollow fiber packings on distillation of IPA/water system

Influence of Random Arrangement of Hollow Fiber Membranes on Shell Side Mass Transfer Performance: A Novel Model Prediction

CFD-DEM Simulation of Flow and Mixing Behavior in Downers with Different Entrance Structures

Application and performance of Dean vortices flow with spiral modules on membrane separation

Effects of baffles on separation of aqueous ethanol solution with hollow fibers

Measurement, Modelling and Analysis of Residence Time Distribution Characteristics in a Continuous Hydrothermal Reactor

Numerical Simulation of Shell-Side Flow in Hollow Fiber Modules

Experimental Velocity Measurements and Effect of Flow Maldistribution on Predicted Permeator Performances