Abstract:Hollow fiber membranes fabricated via dry/wet phase inversion method usually have two dense skin layers,which will increase its resistance of mass transport as a support membrane. It is necessary that the dense skin layer of support membrane has been eliminated to improve separation performance of composite membrane. The excellent. chemical resistance of poly(vinylidene fluoride) (PVDF) to many acids and alkalis has made it as an attractive membrane material, and then it's often fabricated as porous hollow fiber membrane by phase inversion. In the process, the formation of the skin layer is due to the rapid exchange between solvent and coagulation, so many attempts have been made to slow it, so as to control the formation of the skin layer. In this paper, it has been found that the fabrication progress becomes unstable, and the membrane prepared has noncircular lumen, when the "weak" or "soft" coagulation is used. To increase the fabrication solution stability during membrane formation, dope viscosity was focused in this experiment. Dimethyl acetamide (DMAc) was used as solvent as well as internal coagulant, and the additives including LiCl, water and surfactant Span were chosen to investigate their effect oil the viscosity of the fabrication solution. The dope viscosity will greatly increase after adding LiCl, while the variety of dope viscosity is unconcerned in the fabrication solution concentration as adding water. The homogenization and stability of the fabrication solution are improved by adding Span,and the viscosity increases at the same time. Without increasing PVDF concentration, the stability of the nascent membrane was improved by increasing the fabrication viscosity. The PVDF hollow fiber membrane with the structure of single outer skin layer and finger-like pore through the cross-section, has been successfully fabricated. The mean pore radius and water flux of the single skin hollow fiber membrane were greatly improved.

Effect of coating based on various hollow fiber packings on distillation of IPA/water system

Physicochemical Characteristics of Hollow Fiber Structured Packings in Isopropanol/Water Distillation

PIM-1/PAN Thin-Film Composite Hollow Fiber Membrane As Structured Packings for Isopropanol (ipa)/water Distillation

Effect of Fiber Packing Density on Performance and Mass Transfer of Hollow Fiber Membrane Contactor

Effect of packing density of hollow fiber contactors on shell-side mass transfer in distillation

Distillation of Alcohol/water Solution in Hybrid Metal–organic Framework Hollow Fibers

Ethanol-water Separation in Hollow Fiber Membrane Contactor

Distillation Performance of Using PVA/PAN Hollow Fiber Composite Membrane As Packing to Separate the Ethanol-Water Solution

Separation of Alcohol−Water Solutions by Distillation Through Hollow Fibers

Distillation of Methanol–water Solution in Hollow Fibers

Heat-Treated Polyacrylonitrile (pan) Hollow Fiber Structured Packings in Isopropanol (ipa)/water Distillation with Improved Thermal and Chemical Stability

Preparation and application processes of difunctional hollow fiber composite membranes with catalysis and pervaporation

Influence of Dope Viscosity on the Fabrication of Pvdf Hollow Fiber Membranes with Single Skin Layer

Preparation of PVDF/CaCO3 hybrid hollow fiber membranes for direct contact membrane distillation through TIPS method

Preparation of PFSA‐PVA/PSf Hollow Fiber Membrane for IPA/H2O Pervaporation Process

Preparation and performance of silicone rubber/PVDF hollow fiber composite membrane for membrane distillation purpose

Effect of Polymer Molecular Weight on Structure and Performance of PVDF Hollow Fiber Membranes Prepared Via TIPS Process with Co-Extrusion of Solvent Using Triple Orifice Spinneret

Optimization of Coating Solution Viscosity of Hollow Fiber‐supported Polydimethylsiloxane Membrane for CO2/H2 Separation

Hydrophobic tuning of PDMS-PVDF hollow fiber membranes for enhanced isopropanol recovery in pentane diol production process via pervaporation

Study on the preparation of PDMS/PSF hollow fiber composite pervaporation membrane

Preparation of Dual-Layer Cellulose/polysulfone Hollow Fiber Membrane and Its Performance for Isopropanol Dehydration and CO2 Separation