Abstract:A Taylor–Couette (TC) reactor has been considered as a promising technology to produce uniform ultra-fine particles with controlled morphology and size because of its rather narrow shear rate distribution in comparison to a conventional stirred tank. However, small particles in the TC reactor are likely entrapped by the Taylor vortices and concentrated more in the core of the vortices, thus having an adverse or a positive impact on producing the uniformly fine particles. To mitigate this disadvantage, one approach is to adopt an inner cylinder with a variable cross-section through the proper design to obtain a non-constant gap between the inner and outer cylinders in the TC reactor. This study investigates the use of specific profiles of the cross section for the inner cylinder to deform the Taylor vortices, effectively reducing the regions of low velocity and shear rate in the TC reactor. The profiles are composed of a series of curves. The flow patterns and shear rate distributions in the modified TC reactors were investigated using CFD modelling. The sliding mesh method and the Reynolds stress model were employed in the simulation to account for highly turbulent rotating flows. The simulated results compared with those for the classical TC reactor clearly indicate that the regions of low shear rate are effectively reduced in the modified TC reactors because the Taylor vortices occurring in the gap becomes temporal-periodic with respect to the stationary outer cylinder. The obtained shear rate distributions are remarkably narrower than those of the classical TC reactor. It was revealed that the curvature of curves for the cross-section profiles can significantly affect the shear rate distributions, and there exists an optimal profile for the inner cylinder cross-section.

Residence time distribution in a new horizontal self-cleaning reactor with viscous media

Study on fluid flow and residence time distribution in Taylor vortex flow reactor

Study on Residence Time Distribution of Fluid in the Taylor Reactor

Hydrodynamics in a Novel Gas-Liquid Cocurrent Bubble Reactor and its CFD Simulation

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

Mixing characteristics of fixed bed bubble reactor

CFD Simulation of Shear Flow and Mixing in a Taylor–Couette Reactor with Variable Cross-Section Inner Cylinders

Particle movement characteristics in a gas-solid vertical single helical ribbon agitated reactor

Simulation and Experiment of Residence Time Distribution in Short-Contact Cyclone Reactors

Liquid flow residence time in a fibrous fixed bed reactor with recycle

Residence Time Distribution and Modeling of the Liquid Phase in an Impinging Stream Reactor

Model and Experimental Study of Relationship Between Solid Fraction and Back-Mixing in a Fluidized Bed

Simulation of sludge settling property in a novel outside cycle anaerobic reactor

Residence time distributions in microchannels with assistant flow inlets and assistant flow outlets

Experimental study and simulation of residence time distribution of liquid in jetentrained bed reactor

Hydrodynamic Characteristics Assessment and Modeling of A Novel Membrane-Aerated Reactor

Study on Hydrodynamics and Mass Transfer Characteristic of a New Gas-liquid Reactor

Flow Characteristics of Biomass Particles in a Horizontal Stirred Bed Reactor: Part II. Modeling Studies on Particle Residence Time Distribution and Axial Mixing

Measurement, Modelling and Analysis of Residence Time Distribution Characteristics in a Continuous Hydrothermal Reactor

Residence Time Distribution of Impinging Stream Reactor

Modelling and Numerical Analysis on Residence Time Distribution Characteristics in Continuous High-Pressure Hydrothermal Reactor