Abstract:Hydrogen-rich syngas production via diesel steam reforming (DSR) is of great interest because of the high H-2/CO ratio and available external heat sources. In this study, catalysts (particle size (d(p)) = 3-5 mm) containing 10 wt % Ni were prepared through wet impregnation, and their performance was evaluated in a semipilot fixed-bed reactor (Phi = 42 mm). The catalyst was doped with La, which resulted in excellent catalytic performance under different operating conditions. The apparent activation energies of the catalysts for the model diesel (n-dodecane) steam reforming increased in the order Ni/Ce0.75La0.25O2-delta-gamma-Al2O3 (17 kJ/mol) < Ni/CeO2-gamma-Al2O3 (18 kJ/mol) < Ni/gamma-Al2O3 (27 kJ/mol). The model DSR over Ni/Ce0.75La0.25O2-delta-gamma-Al2O3 showed product stability and produced a high H-2 content (32 vol %). Fresh and spent catalysts were characterized by X-ray diffraction, N-2 adsorption-desorption isotherms, H 2 -temperature programmed reduction, inductively coupled plasma-mass spectrometry, X-ray photoelectron spectroscopy, scanning electron microscopy, energy dispersive X-ray spectroscopy, transmission electron microscopy, and thermogravimetric analysis. The origin of the oxygen vacancies in the La-doped catalyst was elucidated using density functional theory calculations. The improvements in the activity and stability of the Ni/Ce0.75La0.25O2-delta-gamma-Al2O3 catalyst are attributed to (1) the enhancement in the oxygen release/storage capacity, (2) the stabilizing interaction between Ni and the surface La2O3 phase, and (3) the small size (11 nm) and uniform distribution of Ni particles. Out of the tested catalysts, the spent Ni/Ce0.75La0.25O2-delta-gamma-Al2O3 catalyst showed the lowest coke deposition (5.8 mg/g-cat.) and the least severe Ni agglomeration after 10 h of testing because of its superior ionic mobility and oxygen storage capacity.

Dimethyl Ether Steam Reforming for Hydrogen Production over Cu-Ni/γ-Al_2O_3 Bi-Functional Catalyst

Steam Reforming of Dimethyl Ether over Coupled Catalysts of CuO-ZnO-Al2O3-ZrO2 and Solid-acid Catalyst

Steam Reforming of Dimethyl Ether over Coupled Zsm-5 and Cu-Zn-Based Catalysts

Ni-based bimetallic catalysts for hydrogen production via (sorption-enhanced) steam methane reforming

Hydrogen Production from Steam Reforming of Ethanol Using Ni/CeO2 and Ni-Cu/CeO2 Catalysts

Dme Synthesis From Co/H-2 Over Cu-Mn/Gamma-Al2o3 Catalyst

Oxide-modified HZSM-5 for efficient production of hydrogen via steam reforming of dimethyl ether

Experimental and DFT Studies on Diesel-Steam-reforming to Hydrogen over a Bimetallic Rh–Ni-based MgO-Al2O3 Microsphere Catalyst

DME Synthesis From CO/H<sub>2</sub> over Cu-Mn/Ă-Al<sub>2</sub>O<sub>3</sub> Catalyst

Hydrogen Production Via Model Diesel Steam Reforming over a High-Performance Ni/Ce0.75La0.25O2−δ-γ-Al2O3 Catalyst with Oxygen Vacancies

Oxidative Steam Reforming of Methanol over Cu-Based Catalysts

Hydrogen Production Via Steam Reforming of Methanol on Cu/ZnO/Al2O3 Catalysts: Effects of Al2O3 Precursors

Experimental and Dft Studies on Diesel-Steam-Reforming to Hydrogen over a Bimetallic Rh–Ni Microsphere Catalyst

Direct Synthesis of Dimethyl Ether on Supported Cu-Mn Catalysts

DME Synthesis From CO/H 2 over Cu-Mn/Ă-Al 2 O 3 Catalyst

Fe–Ni–Ce–Zr-modified CuO–ZnO catalyst for methanol steam reforming

Studies on Ni/Al2O3 Catalyst for Hydrogen Production from Ethanol Steam Reforming

The Cu-Al2O3 Interface: an Unignorable Active Site for Methanol Steam Reforming Hydrogen Production

Improved performance of Ni/Al2O3 catalyst deriving from the hydrotalcite precursor synthesized on Al2O3 support for dry reforming of methane

Production of hydrogen from dimethyl ether over catalysts

Pd+Al2O3-Supported Ni-Co Bimetallic Catalyst for H2 Production through Dry Reforming of Methane: Effect of Carbon Deposition over Active Sites