Direct Synthesis of Dimethyl Ether on Supported Cu-Mn Catalysts

Zhaoyin Hou,Jinhua Fei,Gong X. Qi,Xiao Ming Zeng
2000-01-01
Abstract:A new catalyst system of Cu-Mn-M supported on γ-Al2O3 was developed for dimethyl ether (DME) synthesis via CO hydrogenation in a fixed-bed reactor. The catalyst was prepared by directly co-impregnating the nitrate of Cu and Mn on γ-Al2O3, and then dried and calcined. Promoters such as Zn, Cr, W, Mo, Fe, Co, Ni were used and tested. Results show that the catalyst has the highest reactivity of CO and a high DME selectivity when n(Mn)/n(Cu)=2/1. The addition of a small amount of Zn can increase the selectivity of DME. The best DME yield reaches 46.0% (at 63.5% conversion of CO) under 2.0 MPa, 275°C and 1500 h-1 on Cu1.2-Mn2.4-Zn/γ-Al2O3 catalyst which is higher than the hybrid catalyst consisting of a methanol synthesis catalyst and a dehydration catalyst. At the same time, the catalysts have high stability and good mechanical properties, and are easily repeatable. However, the main product of CO hydrogenation was CH4 on addition of Fe, Co or Ni on Cu1.2-Mn2.4-Zn/γ-Al2O3.
What problem does this paper attempt to address?